QUOTE(Siilver @ Jun 3 2015, 03:58 AM)
I got the same problem too when I first got the VS and the Subtank.
The reason why is because the RBA and the connector at the base does not touch. When you remove the RBA from the base, you'll see a gold pin in the middle of the base. The RBA is too short to to touch the connector.

To solve this, the easiest and fastest way is to cut a small piece of kanthal and place it on top of the gold pin before locking in the RBA. This will allow current to pass through to the RBA.
Bro,The reason why is because the RBA and the connector at the base does not touch. When you remove the RBA from the base, you'll see a gold pin in the middle of the base. The RBA is too short to to touch the connector.

To solve this, the easiest and fastest way is to cut a small piece of kanthal and place it on top of the gold pin before locking in the RBA. This will allow current to pass through to the RBA.
TQ !!!!!!!!
This post has been edited by rastablank: Jun 3 2015, 03:56 PM
Jun 3 2015, 03:55 PM

Quote
0.0421sec
0.57
6 queries
GZIP Disabled