the interior is silver or copper colour like picture ?? if copper colour really nice then, it's expensive anodizing they are putting.......

the side bracket for holding graphic cards ??

wah sniper got a A10, nice............... lagi ada rebate cantik, last time i ask tak ada rebate bagi i pun...........

but shawty uncle ho said need to drill wor......... rail need to be remount completely........ it's a bit difficult to get a accurate hole drill without disassembling the casing itself

This post has been edited by LExus65: Jun 15 2007, 06:15 PM

the fan filter looks good, i might be getting some from Gary too.........

btw u dun need to buy a sieve, u can get those mosquite net like from hardware shop, but buy aluminum 1.......if not get rust very fast

there are a lot types of mosquito net, but the price wont be cheap.......so if u can get a cheap sieve, why not.......

i dun think the thick and thin fan got much difference, mostly on the blade design..... try to a get a fan with good pressure........ 2mmh20 above ( but super rare here)........if not mistaken good presure can penetrate the air filter easily while still maintain the air flow rate

so far i only notice silverstone and certain thermaltake models does have those pressure ratings but the price also haha.........

or u could do like a silverstone casing tj09 does, put a fan inside the casing in between the hdd rack and mobo

another way is to keep a distance inbetween ur filter and fan like thermal take tsunami / soprano casing

i like to take A10 earlier too but after seeing how could i convert it to BTX, wah......retreat.........haha

but seriously a71 would be better choice, those 4 fans configuration between the hdd rack and mobo area really nice

btw sniper, vizo fan are no good with fan filter unless u stick it on a heat sink.... the pressure very weak....... mine was making a mess to the airflow after installing it with a fan filter...

the hdd cage ATE have stock now, i went yesterday.....really nice and cheap...... and definately can fit into ur case

This post has been edited by LExus65: Jun 21 2007, 04:36 PM

go buy now lor............got black edition some more same price....... i think goin get 1 this weekend to stuck it inside my stacker........

thx for advice ianho, i'll try to measure out and see........ i think it's possible after have a study at it few days ago..

as i have intension to remove the front panel of the EX33, so it ok from what i measure....... if cannot fit i just keep it for my next case lor haha......

btw nice mode bling bling there ^666^......... but those red fans abit stick out, may be can try some of uglyvamp UV LED fans..........

This post has been edited by LExus65: Jun 22 2007, 08:26 AM

haha i notice that fat side too........hehe but the mesh looks could perform good though....

^666^goin Ali G style too..........wah....... i'm really looking forward to see it............

but as for case fan, i dun recommend Vizo or anything around 30dB if u place ur casing just next to urself on the table for gaming or movies, a bit annoying after a while......

for me i stuck 3 vizo in my casing, and the case is on the floor yet it still annoy me once a while

beware of the rought edges, it not easy to smooth it up as it a bit soft

haha sniper.................. study carefully 1st before putting ur saw on it haha............

i tot u want to cut plate to make it larger......like op1000 cannot fit in most psu back plate nicely

Dual PSU is kind of cool, but the heat problem is hard to tackle in some event,

sniper i tot u sold ur x1900xt already ?

btw i bought and install EX-33, (i'm not sure which model, mine hold 3hdd). it work better then cooler master own steel 1, and very light. easy to install as well. But the ori fan a bit slow, i replace it with a vizo hehe........but the fan holder a bit weird, a quater of the area is slight block (i dunno why they dun cut it clear) ........... sniper i definately recommend it for u............ but careful while install get scratch easily......

btw as for ur GC cooling , i suggest cooling the underneath too......when i remove a fan blowing the lower section the temp shoot to 67oC at idle, put a fan back on 63oC.........put 1 more 60oC.....may be u should try that........

note that all the fan are focus on the underneath of the graphic card

sniper may be u should try attach 2 fan on the HR-01, perform much better for mine, but the weight side a bit problem though haha.....

btw as for ur HR-03, i suggest u still the fan blowing towards the rear, but u have to find a way to mount the fan, ur sound card is blocking the air intake of the fan

yeah finnaly another fellow with frontal 2 x 120mm fan

u can cut ur rom slot, or make ur own mesh grill...save money too....

i bought the EX-33 because i need it hehe........

btw i need to ask for some opinion, i went to ATE today and saw this pc-60 plus II, now newest edition come with transparent side panel and best of all removable mobo tray......price is quite ok too

what do you guys think, let say some weakness that i should take note

This post has been edited by LExus65: Jun 30 2007, 12:00 AM

EX-33 price.. ATE didnt gave me discount, Dooms is selling cheaper as far i know...... ask form Doom.....

i do notice the 8cm exhaust , but the side fan exhaust is 12cm....so it a + - situation.........

8800GTS tend to run idle at slightly higher temperature after using for some time..........

u might want to turn ur fan speed up from 60 % to may be 80%, it's still very quiet for me.......mine idle at 63 shoot up to 67 before i manually tweak the fan, after that goes down to 60 only......hehe

well u can go CM thread look for my casing setup....... i think the problem due to dust collection and fan aging n performance deterioration for 8800GTS.......

now trying to troubleshoot the problem why the temp keep goin up

but i manage to keep the temp down below 70 under gaming, so far only CnC3 and supreme commander.........i think still does not stretch it out far enough

so may be u can do like sniper did, 2 2x120mm frontal intake, this helps alot

This post has been edited by LExus65: Jul 2 2007, 05:43 PM