@ikan_semilang

Actually it is not for all the Lian Li case .. only V-Series able to mount it without any modification.

There's always holes at the bottom of the case .. but it doesn't mean those are align with the wheel..

As for PC-A10, I'm not sure whether it align or not .coz never tried...

However G7 definitely can't fit it on .. coz last time I wanted to mount it ... but it just doesn't align at all .. must drill the case ..

Anyone could show photo of the bottom of case and the wheel stand to make comparison cases that could fit and those that can't .. 

this could solve most forumer's doubt ...

This would cost you RM35 each for black and RM30 for silver...

Removing the finger print ??

Clean with soap water and wipe it nicely with a cotton cloth

or

Get window cleaner, aluminum polisher, WD40 and etc ...

I prefer just to clean it with soap water, or detergent ..

@ikan_semilang,

I bought mine at ATE for RM35. Very nice one indeed. Makes the casing look so much better..

I normally clean the casing with cloth and water only. But you will need to really wipe hard for all the stain to be removed..

LOGO ??

hahah just ask sticker shop make u  a new one with ur own LL design ..

that bezel should be fit in all LL aight? , gonna get minela for A10S , looks funny, Pioneer black bezel with silver A10

Itu untuk exhaust fan bang.

no need to use it. its kinda hard to install the fan because on the wires coming from psu..
im thinking of closing it by using a aluminium fan filter..

U can setup the fan either way. If u think ur case need more fresh air, make it as intake else as exhaust like said by sHawTY. But if u setup as exhaust, make sure ur fan is powerful enough else u wont feel any air coming out from there as normally the rear 120mm fan will suck almost air out. I used a 80mm Panaflo M series fan on my previous G7. Worked real fine.