Hey guys, I just want to share what I have done to my board for the past week. It has been a hectic 2 weeks putting in my watercooling setup and my phase change retention system. But what I think most of you want to know is to mod a motherboard without ruining your warranty.
When people say volt modding, people think it is un-safe and they will think of warranty if anything goes wrong. Well there are pencil mods, where you add resistance but drawing lines - which is not very reliable. And then there is a tool called grabbers.
In this guide of mine, you will need these things:
- Digital Multimeter
- Pomona MiniPincer and Micrograbber
- A molex connector (preferable female
)
- 2 x 20K pots/variable resistors
- Soldering Iron 15W or 30W, wire cutter and a wet sponge
- Hot Glue gun
- some wires(preferable colored - black and some other bright colors)
- a steady hand
- and of course a board as your victim
Keep in mind not all VMODS can be done with grabbers. Some of them don't leave u any choice but to solder them to the board, voiding warranty. So make sure you know what is required for your mod.
Now on to the next post.........
why am i knot this creative..? damn i am lazy..