Post up some cpu-z SS,maybe we can help.

Or u can ask bro tapirus,cuz he's using the same mobo like yours.

This post has been edited by ocz: Dec 14 2007, 11:07 PM

Bro,change the multiplier to x10 and set the cpu freq to 200.

Oic,try to disable it 1st then u can do OC.
Whats the cpu speed r u running now?

Now can see d.
Well,have u tried to increased the cpu freq? such as 220mhz x 10? 240mhz x 10?

Allrite,in that case.have u push the vcore?

Put some ss of your ram timings and speed.

But before you push the vcore,make sure u use a good HSF.its just in case.
As like for ram voltage,you also need a ram cooler or other cooling before you increased the voltage.

But,if u are doing 2.45ghz i dont think there will be a problem.I tried before with only usint stock HSF.

1.4v is enough to pump 2.4ghz d.As for the vdimm leave it 1st.

make sure you loose all the ram timing 1st.It will be more easy to halp if u have those SS.

I hope u can provide a ss in detail in cpu-z for the ram speed.
So easy to tell the timings to you.
And also can help you on what to.

The rest ok d.Just try to increase your cpu frequency.
Increase a bit vcore.it wont harm your rig.

There you will notice your ram speed will increased.

The HT link set to lowest 1st.then later u can increased it.

Well good luck bro.waiting for a good news from you.

Can,all depends on the cooling.

Normally around 55 to 60C.

Nice bro,whats the HT link u use? is it 600mhz or 800mhz?