Post up some cpu-z SS,maybe we can help.

Or u can ask bro tapirus,cuz he's using the same mobo like yours.

Bro,change the multiplier to x10 and set the cpu freq to 200.

Allrite,in that case.have u push the vcore?

Put some ss of your ram timings and speed.

But before you push the vcore,make sure u  use a good HSF.its just in case.
As like for ram voltage,you also need a ram cooler or other cooling before you increased the voltage.

But,if u are doing 2.45ghz i dont think there will be a problem.I tried before with only usint stock HSF.

1.4v is enough to pump 2.4ghz d.As for the vdimm leave it 1st.

make sure you loose all the ram timing 1st.It will be more easy to halp if u have those SS.

I hope u can provide a ss in detail in cpu-z for the ram speed.
So easy to tell the timings to you.
And also can help you on what to.

The rest ok d.Just try to increase your cpu frequency.
Increase a bit vcore.it wont harm your rig.

There you will notice your ram speed will increased.

The HT link set to lowest 1st.then later u can increased it.

Well good luck bro.waiting for a good news from you.

try to pump more Vdimm...ur proc not enough juice there...

no..but please dun put more then 2.1..2.1 consider safe for daily use...

a friend of mine have this mobo also..he said it doesnt have auto reset CMOS isnt it?
whenever u fail to OC, u need to reset CMOS manually rite?

so its true ler...
but still better than my mobo, ur mobo support vdimm higher than mine

ya i have it...i hate to clear cmos by jumper..cannot auto reset it...need to pull out power cord..then change jumper...now i good enuf to change jumper without see where it place.. no already it position...  but this mobo only have 2.3 for max vdim...

why u pening??with it interface or something else???

u must start with everything on stock..then u change the divider to 400..then u push ur fsb slowly..by the time it cant boot when u increase the fsb, u raise ur vcore step by step, untill u can boot,..do this till u find ur cpu limit..then after u found it, play with ur ram afterward..change the divider and set the timing, the vdimm, blablabla

driver missing???weird...if u use all stock back can log into windows or not???

if yes..u do like what alive88..when bsod or cannot boot into windows up ur vcore a bit..then raised ur bus speed little by little..but remember u need to increase ur vdim also...

checked ur temp also for safety!!!