Hi, I just installed a boston component set( SX60), n two channel amplifier(80W).
The sound play from cd is very very clear n nice, however, when I change to FM, I noticed that there is significant drop in sound quality, really terrible. Any solution?

My amp is.connected to the component set, while rear 6*9 connect to hu(pioneer).
Haven't instal any sub n monoblock yet.

M trying to take a balance between sq n spl.

This post has been edited by kinmin888: Mar 16 2011, 02:49 AM

So basically how to tune the amp?
i had a two chanel amp, which has a lpf, hpf , n cross over (all, high, low) n it is connected to my front component set.

my current setup is lpf=20, hpf = x sure (later I check), x over = low, it produce a decent sound for those oldies but not for some rnb song.
how to tune for a bälance sq n spl setting?

nop, its x the amp for sure. Zomg.
m just wanna learn how to tune the amp, jst wanna learn smtg n gain sme knowledge.

Ok. I had check.

The x over =hpf, hpf=1khz, lpf=250hz.