Peugeot recommend 5w/40 for 2.0 liter engine.
In fact, Petronas syntium 3000 shall be used..

Good morning.
I in SC now, to replacing faulty steering rack.. Three technician looking at my car, they seem like discuss something. A lot of part need to dismantle before steering rack can demolish. Kasiah my car...

This post has been edited by chenglong: Aug 19 2014, 09:25 AM

408 NA using hydraulic for steering system. It have noise when turning in certain angle due to pump. This is normal. Some car brand have also similar noise...

My case is difference than above...

When driving, I can heard the noise coming from front bottom especially during morning and rough road. When it was new car no issue. After used few month, this noise occurred. I tot it was caused by contact plastic and plastic on the steering so I tried to readjust steering position but problem still persist...recently this noise happened very often so I bring it to check when I does 30k service. I already recorded the noise using phone, later I upload to here...

New steering rack inside seal box. Technician took photo of my car number. SC free alignment for me but balancing i use own pocket money...

My lion still live strong, love it very much..LOL

This post has been edited by chenglong: Aug 19 2014, 10:38 AM

Hi all,

Can install stiff ring in 408 ?

Thank you

This is normal. If you turn the car key to initial without engine for certain time, system will cut-off the the power for energy saving to protect your battery.

For example, you listen to radio without start engine, economy mood will activated after certain time.

correct me if I'm wrong.

Hi,
Anyone change the tyre ? Can recommend to me please? Now I plan to change two tyre and I was thinking to use spare tyre, continental mc5. In the end, I just buy one tyre.. Can?

My pug white almost clock 40k also, think to send to service soonest.
replace Aircon fitler is mandatory, is MUST.
Aircon service, depend on you.

Which sc you did 40k service ?

if you think to install front sensor, you can purchase the parts from China. The parts consists of
1. one new Bosch controller (supports eight sensor)
2. four new sensor for front
3. cables
4. support/ bracket

You are require to change the existing sensor controller (Bosch). You can found existing controller located at rear boot (hidden inside the black insulator, left hand side). Existing controller in our car only support four input for four rear sensors. The new controller (Bosch) can support eight sensors ( 4s rear, 4s front)

You bring it to car accessories shop to install it. After that, you need go to service center to activate the new sensors.
After activated, when engage reverse gear, front sensors will start working (you able to see it in center screen\\

See the link (how to install front sensor for 408)
http://club.autohome.com.cn/bbs/thread-c-987-26041555-1.html

This post has been edited by chenglong: Oct 12 2014, 11:55 AM

In Malaysia, you cant find the part if Im not mistaken. Or you can ask spare part shop (major Citroen/Peugeot part)
Alternative way, you buy aftermarket product that come with external screen itself.

For me, i prefer to integrate into existing system because i don't like put many stuff at the dashboard.

I've checked the price for full set for front radar, cost about RM700-800. Installation not inclusive, so worth it or not very depend on personnel.

Yesterday, I does the dismantle the front door panel, I found that our car can install welcome light because cable and socket already there, but no light. I've measured voltage, 24VDC. We just buy the light and install it. The light will on (received 24VDC) when we open car door and off (received 0VDC) after door closed. This, nice





This post has been edited by chenglong: Oct 12 2014, 02:23 PM

The light can only get from China.
We have pre-cut socket and cable so we buy the light only
This is mine pug



This post has been edited by chenglong: Oct 12 2014, 02:35 PM

Hi all,

Who can read mandarin, here is new 408 1.6THP spec full photo that provided by China 408 forum

http://club.autohome.com.cn/bbs/thread-c-987-34235522-1.html

Can share the photo over here please?

Consider cheap...
I just changed..RM420 (balancing, filled with gas nitrogen) in Hin Leong, Klang...

Hi all,

To share E-NCAP ESP/ESC test video for peugeot, Volkswagen, ford

http://club.autohome.com.cn/bbs/thread-c-877-19785778-1.html

Nice, Thank you for sharing.
I already ordered the light from China.
Your car have leg light?

Nice bro. Leg light at the Front only? It always on during car running?
Mine have pre-cut for light but no light and cable.
Think to lay cable by myself.

This post has been edited by chenglong: Oct 21 2014, 03:45 PM

cover broken ?

I use Solar Safe, quite nice...