because way signal LED is become different
it's normal

Sorry for a stupid question... there is no logout button on the modem browser interface?

I not sure, I never logout

Anyone manage to set dns in the firmware? I must set manually for each device..how to set up for all devices?

go to LAN

a stupid question here
if the Riger modem is not beside me
can i deltect the mac address by using command pront?
need the Adm@**** password thing

better look on modem sticker, mac address can change

formerly use db108wl.
recently changed to db120-wl.
how can i assign IP address for certain MAC address?

Interface Setup → LAN

And?
Where to key in MAC address?

I just logged in to show my appreciation for TS.
Sir, thank you very very very very much for this idea of updating the firmware.
It solved the problem of random disconnection during gaming like, INSTANTLY!
The firmware really stabilize the Riger router.

I can now play games with no insecure feeling of getting random disconnect during gaming.
This update is very recommended for everyone.
Just follow the easy steps and, enjoy!

THANK YOU, SIR!

Glad to hear it :3

Edit: Solved below

I upgraded the firmware following this guide many months ago, but I've never reset it to factory settings. It has not give me any problem until today after the reset, I can't connect to the internet anymore (the light for internet is constantly on and DSL is off).

What I did:

1. Reset to factory default settings
2. Run quick start wizard
3. Change time zone, enter username and password, change vpi value from 8 to 0 (0/35), setup wlan then save
4. Change channel to Malaysia

Any idea what am I missing? I tried deactivating all the PVC except PVC0 and set it to 0/35 as well but no luck.





This post has been edited by Groundnuts: Feb 12 2016, 11:58 AM

Your ADSL is established, so maybe your account

Ah, it shouldn't be because I'm using the same account on this older modem right now.

This post has been edited by Groundnuts: Feb 12 2016, 12:00 PM

Go to "Advanced Setup" -> "ADSL"

ADSL Mode change to "Auto Sync-Up".

ADSL Type change to "ANNEX A/I/J/L/M"

restart modem.

That was the setting. But I changed it to ADSL2 and it is working now. Thanks!

If you didn't reset to factory default after flashing, you will suffer with TM WiFi back doors, people can use your internet without need to crack

Delete other PVC then set PVC0 to 0/35

This post has been edited by Anime4000: Feb 12 2016, 11:55 PM