can u try one thing for me?

open up ur bonnet and push the bonnet down with ur 2 hands... can u hear any weird noise from rear absorber/spring when it bounces back?

other vios owners can try too perhaps?

=.=

use remote of course la or can open from driver's side near to where u open fuel pump.. or u can press any rear area... try to pull down and hear got weird sounds or not when the absorber bounces back?

Btw, Toyota Malaysia aka UMW had recognized both the loose brake pedal and formt knocking case. They are looking into it.

Today sent in for 5k service and complaint the same case. They told me that they're pending confirmation from HQ on which cause the issue, and the rectification process. Most likely a recall in newr future.

Hope this is a good news for every new Vios owners.

yeah i mean rear bonnet... open ur rear bonnet and push with ur 2 hands to test the absorber.. try see whether got funny sounds or not haha..

Now my driver side B pillar got this rattling noise... Damn it... Cheap built car indeed it is.
Open ur driver side door... Look at dashboard, most right edge, there is a lever to pop your car hood up.

Its there la, a lever to pull one.

I think we can reduce the wind noice by blocking the air flow from underneath front bonet where there is a big bloody hole connecting to our A pillar.

Plan to diy and stuck something there to block the wind going through.

Do try to pop up your hood and look at each pillar... Damn big hollow space to create resonance.

Thailand's car plate..Malaysia got this color d ?

Do they sell this separately?

Same like the body kit... After new car purchase, Toyota entertain anymore.

bro, your door also got the rattling sound? i have this problem too.

whats the root cause? mind to share the solution?

really lazy to go back and wait for hours to solve it. btw, how long does it takes for SC to solve this issue?

thanks alot.

SC solve useless. Don't believe u can try after few days or week the sound will come back eventually.

better DIY 101% sound wont come back

any solution to share?
choi!! another 4hrs!!

perhaps i'll get insulation expert to soundproof my 4 doors one time off to settle it then... if SC couldn't solve it permanently.

they insulate all 4 doors?

Based on the rattling noise and your comment of the service form.

I've did some DIY by inserting medium hard compound foam to the gap between door panel and door. Mainly on the sills that closes to B pillar.

Haven't at least when I simulate it, no rattling noise. Tmrw will try drive around and test it out.

Yup. I can confirm G spec have chrome hands but not the silver as shown in your picture

I didn't take off the door panel coz scared later the plastic pin broke.

When u ope your rear driver side door, look to the left on the panel... Try put some pressure on the door panel and you will hear the rattling sound... There's so much gap in between!! So, I only slot in thick triple folded doubleSided tape into 4 separate distance on the door panel gap. At least now when I press it, no rattling noise.

Tmrw morning it'll snap a pic to share.

Of course, will around and test it as well. I'm way too lazy to drive back sc again for this. It's very inefficient and tiring.