Welcome Guest ( Log In | Register )

Bump Topic Topic Closed RSS Feed
8 Pages « < 5 6 7 8 >Bottom

Outline · [ Standard ] · Linear+

 PROTON SAGA BLM, FL & FLX Thread V57, Nothing to see here...

views
     
ruby1288
post Jan 23 2014, 05:41 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


HARI INI OFFICIALLY RUBY1288 SUEY DAY !!!

1) Midnite dreamt I bang my car. But I rmb it's just a small scratch (in my dream).
2) Midnite - early morning, keep on wake up non stop. Can sleep, but keep on wake up only.
3) Bring woof woof go jalan jalan, stop by petrol station buy papers, woof woof sked the attendant until ter-pee thumbup.gif . Nasib baik bukan fabric seat.
4) End up below.

Lesson learnt: Belib what you dreamt and take note of the given warnings !!

user posted image

Anybody can advise if I DIY remove bumper and DIY ketuk back, can or not ?
Otherwise, ma kat lou (mahihi brows.gif )? Normally caj berapa mia ?

ruby1288
post Jan 23 2014, 05:45 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


QUOTE(2JayZ @ Jan 23 2014, 05:43 PM)
Repaint whole bumper RM150 if u want  cool2.gif
*
no need repaint la, can polish back.
just some paint transfer and loss of my red paint.
I am more irritated by the dent more than loss of paint

ruby1288
post Jan 23 2014, 05:46 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


QUOTE(TitanRev @ Jan 23 2014, 05:45 PM)
Try lay down on floor and get uner your car and push the bumper from inside with your hand....
*
can reach that part from under ?
I just now squat down had a quick look, put my fingers in, macam cannot reach that part wo
ruby1288
post Jan 23 2014, 05:47 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


QUOTE(2JayZ @ Jan 23 2014, 05:46 PM)
Close one eye.  wink.gif
*
I can close 1 eye later (though now heart very sakit) if only paint loss.
But the big lobang dent I cannot tahan
ruby1288
post Jan 23 2014, 05:54 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


QUOTE(TitanRev @ Jan 23 2014, 05:49 PM)
Squat down hard to reach because hamd not enough long...Try lay down and go under the car...last time I try remove my rear reflector can see the bumper one
*
Ah I got it d.
Went and look again ngam ngam.
Can is can but that part ngam ngam got mounting point, so the mounting point block the direct access path. mad.gif
ruby1288
post Jan 23 2014, 06:01 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


QUOTE(TitanRev @ Jan 23 2014, 05:56 PM)
If hand cannot go inside try use something to reach inside like a rod or ur mum wife gardening shovel..in extreme time use extreme way
*
like that push back out the effect may not be that naise if u remove the bumper and use yin&yang force to slowly push out ?
if the access path is clear of blockage then still can.
aduhai vmad.gif
ruby1288
post Jan 23 2014, 06:06 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


QUOTE(TitanRev @ Jan 23 2014, 06:04 PM)
put a piece of old cloth between the bumper and the tool you use to push so won't cause any damage...
*
look what I found
u heard / tried before ?



always listen to Daddy laugh.gif

This post has been edited by ruby1288: Jan 23 2014, 06:14 PM
ruby1288
post Jan 23 2014, 06:20 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


QUOTE(TitanRev @ Jan 23 2014, 06:15 PM)
Yes, heard of this and tried too....what the hair dryer does is make the dented area more easy to push out but you still need to push from the back right? Also you will need a high powered hair dryer like thosesaloon one if only those house use small one you need 2 of them. It just makes it easier to push out. You can try, no harm.
*
yes, still need to push from back cry.gif
hehehe, its good to have ur waifu / gf with long hairs. .
Y ? Damn sure u will have more than 1 hair dryers lying at home. laugh.gif
I got 1 normal dryer with a "turbo" function, higher output wind speed
and gf got saloon type dryer
good to go then icon_rolleyes.gif
ruby1288
post Jan 23 2014, 06:26 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010




just want to reassure, is it because of how the bolts are inserted into the chasis like the above video @ 8mins ?
I know not the same car and bar design but roughly its because of the way the bolt is inserted into the chasis and the hole stock diameter makes it not rekomended to remove after install ?

This post has been edited by ruby1288: Jan 23 2014, 06:27 PM
ruby1288
post Jan 23 2014, 06:28 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


QUOTE(TitanRev @ Jan 23 2014, 06:22 PM)
It's the heat from the hair dryer important. More heat better can soften up the bumper more. My wife one can melt plastic if on full heat and full speed. I melted my wiper cover before with that....T_T
*
thumbup.gif thumbup.gif
I'll try and see. unsure.gif
ruby1288
post Jan 23 2014, 06:28 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


Tomorrow got TT ah ?
ruby1288
post Jan 23 2014, 06:36 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


QUOTE(davidke20 @ Jan 23 2014, 06:30 PM)
Hai ya whistling.gif
*
blink.gif one way ticket once you decide to install side bars ohmy.gif
ruby1288
post Jan 23 2014, 06:45 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


QUOTE(dares @ Jan 23 2014, 06:43 PM)
Dun dak jui gunker, else you can never set foot in NS again. If mau go Johor, kena masuk lalu Pahang. If mau go Melaka, kena lalu Pahang, masuk Johor, pastu u-turn ke Melaka  vmad.gif
*
You can lalu pass Seremban.
Condition is u must go >240kph
If Gunker pakai R35 then different story la ok
ruby1288
post Jan 23 2014, 06:47 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


QUOTE(TitanRev @ Jan 23 2014, 06:39 PM)
Can take out, just need to be extra careful and patient. Also due to the nut is bolted in the bar screw hole which is deep once you loosen the nut the bolt will turn together making it hard to remove the bolt. The same with the UR "rear ARB" for gaga which I have previously and when I took it out the bolt and nut was very hard to take out end up I broke 1 of the screw off to take it out. With impact wrench and welding.
*
bolt and hole alignment will be another issue as the bolts are subjected to stress every second we drive the car.
tak remove, ok mia.
sudah remove, kantoi.

FC King LC2K mia FSB pernah kena ma
ruby1288
post Jan 23 2014, 07:01 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


kenjilew I bought this instead of biba cockroach




Attached thumbnail(s)
Attached Image
ruby1288
post Jan 23 2014, 07:11 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


QUOTE(Quazacolt @ Jan 23 2014, 07:06 PM)
lol i took my inspira antennae off tongue.gif
i don't use radio, what for put... they got a placeholder screw on anyways (during car delivery) so i kept that on and leave my antennae in glove box.

less air drag yo brows.gif
*
I morning hear ah beng morning sunshine show geh. .
cannot do rike u rolleyes.gif
ruby1288
post Jan 23 2014, 07:27 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


QUOTE(Quazacolt @ Jan 23 2014, 07:13 PM)
surprisingly, the radio still works... quite ok lol...
*
with some buzzer sound right ?
ruby1288
post Jan 24 2014, 08:13 AM

New Member
*
Newbie
10 posts

Joined: Aug 2010


QUOTE(lhwj @ Jan 24 2014, 12:02 AM)
Somebody's been stalking me and reading all the posts I've ever made here ph34r.gif

Btw ayam not FC king. Still very curious to know how coolkwc can manage to get this in JB whistling.gif

http://www.fuelly.com/driver/coolkwc/saga
*
Mana ada stalk. Talk abt bars ma teringat lu. Hehe
ruby1288
post Jan 24 2014, 08:20 AM

New Member
*
Newbie
10 posts

Joined: Aug 2010


No TT ?
ruby1288
post Jan 26 2014, 11:21 PM

New Member
*
Newbie
10 posts

Joined: Aug 2010


QUOTE(wanfauzan @ Jan 26 2014, 06:28 PM)
Just now got tapaued by naza citra 2.0. Was doing 165kmh at LPT, effortlessly that car smoked me on straight.

Btw, does flx have speed cut or rev cut. Are both same?
*
180 kph still possible. . done that. . icon_question.gif

8 Pages « < 5 6 7 8 >Top
Topic ClosedOptions
 

Change to:
| Lo-Fi Version
0.0510sec    1.27    7 queries    GZIP Disabled
Time is now: 17th December 2025 - 09:13 PM