here mine, assuming HZ is a UCCC


p/s: the only thing u cant/unadvisable to change in windows environment are CAS/Tcl, 2T timing, and Controller mode

oh, dont expect em to go ddr600 easily

its not about worth or not..
its about checking it as is it stable at rated speed, or RMA it goes
the OP didnt even mention if its tested and pass at rated speed with prime/memtest/etc


------------
oh, i see the MAL n RP are freakin tight

This post has been edited by e-jump: May 29 2006, 05:26 PM

probably too tight
what did u put..??

as for me, i did trial n error, took me 3 friggin day to find a stable settings
so, be patient when tweaking..

p/s: did u know what each of those timings are for?



This post has been edited by e-jump: May 31 2006, 08:33 PM

oh snap..
edited

This post has been edited by e-jump: Jun 2 2006, 02:15 PM

uccc @ 260-265


p/s: ignore the speed. as this is a 24/7 rig on power saving mode =__="

^ the great OPB's guide
altho doesnt do justice for me

its nforce4 have better capabilities to oc better than nforce3 ;___;
esp on better bios options n more stable voltage supplies

This post has been edited by e-jump: Jun 21 2006, 09:48 AM

doesnt mind which version..
its juz the layout arrangement and few added options
main advance options still the same

1 or 2 errors only? which test
just use the setting n chech next week if the error went away

oh, my xtreem sticks do have errors in memtest@265 3-4-4-8.. as long superpi 32m ok, no prob for me
but so far, its great at 260 3-4-3-8

maybe ur sticks limit is 255-260.. try tightening the timings instead