Hobbies Air Brush Acessories, Airbrush hose etc.
|
|
 Mar 6 2012, 04:12 PM
Return to original view | Post
#1
|
 
Newbie
0 posts Joined: Mar 2012  
|
hi Guys,
just started my airbrushing experience.... and need some help here  , my prob : 1) i used mr surfacer with my airbrush will this spoil my airbrush... coz after several used it seem that the spray coming out from the airbrush is not smooth (sangkut2)... ??  2) cleaning should i take out everything out or just let the the thinner in the cup and spray it out until finish thank |
|
|
Mar 11 2012, 09:22 PM
Return to original view | Post
#2
|
|
Newbie
0 posts Joined: Mar 2012
|
QUOTE(shauno @ Mar 6 2012, 05:00 PM) if it's stuck, most likely cos the surfacer is not been thinned properly. surfacers are normally thicker, and needs more thinning to be sprayed smoothly.. thanks for the replywhat do you mean by take out everything? basically, just put thinner into the cup, and spray it till its clean   ermm maybe lah i didn't put enough thinner... what is the recommended ratio aa..or thickness we are looking for for the surfacer ? well i take out the pin out...was that a bad thing to do? |
| Change to: |  0.0280sec
 0.84
 7 queries
 GZIP Disabled
Time is now: 5th December 2025 - 10:17 PM |
Quote