decal & detailing line havent apply yet.

that part is transparent plastic with gold sticker.

This post has been edited by limfreelance: Sep 9 2013, 01:22 PM

wooo...delta....too bad it hg, but good for play.

MG ex-s with evolve part ka??

but the evolve part looking good & awesome. Too bad, if the evolve part release 1 year early, i will sure to get 1, bcos it save alot of time & afford...& it cheap compared to resin part.

Looking forward for your Ex-s.

aha..very cincai. Tak sabar sabar mau assembly PGSF.

almost...done...pending custom log decal only.

yup..no matter black or red plastic once u cut it out from the runner will remind the white dot there. for perfection, u can sand it & paint it.


Btw, for the gold color, actually is not so shine, maybe the camera lighting make it more shine.
paint: silver + gaiacolor starbright + anchor gold.

pending my gaiacolor-132 Pearl Gold for testing again.

received my gaia pearl gold. tested it & the diference between:

1) Gaia starbright Gold more yellowish
2) Gaia pearl Gold more orange.

but both color more like a powder or particle (semi transparent) to make the existing paint more shine. In term of effect, pearl gold r much better. But u still need a GOLD color as basecoat bfore applying pearl gold.

so far progress.

woooo. nu rage mode.

fuuu.....nice color. it look soft & elegent.
did u paint the inner frame??

I see.....he using the spray can, quite expensive.

Yup, but use spray can to fully paint that consume alot of money, unless u r using spray can for top coat.
hand paint can only apply in small portion like touchup. To make the hand paint look well, u must need to apply alot of leveling thinner, hence it can only apply for GK/ PVC instead of plastic kits.

cannot direct spray white color into blue, it will look abit blue in the white. U need to paint silver 1st before apply white...& after u cut the piece from runner, u may need to trim or sand it...leaving a Dark Hole there.

yup dark hole can be touchup by paint brush. If u change the color scheme, it really take alot of time..unless u topcoat the original color after decal, it save time & cost.

damn..that liger panzer.

btw, becareful when playing the pg wing, i try to take a photo of fullbust, but suddenly the wing felt like loose...then..


anyway, just finish it. unable to deploy the wing

yup thet one loose, when turn it, it keep pop out. overall the PG is just for display only.

i think most of the ppl also faced the same problem of PG sf, like paint incompleted in certain part, loose or too tight. Bcareful when assemble the wing part, the direction of the "Inner Hook" (my hook broke), if wrong direction the wing cannot fully deploy.

fuuuu..that arf prime look awesome, it bring out the robot feel. the ARF body really suit to paint this silver color.

the current mc qubeley articulation quite loose. Does this solve the loose problem??

any possible for china brand to replicate it?? Bila mau copy ni???




This post has been edited by limfreelance: Oct 7 2013, 10:36 AM