QUOTE(KIW_91 @ May 23 2013, 06:04 PM)
hi. buying my first mech mod. which one is better k100 or kts? and buying a drip tank. smok rda or era clone, which one is better? i acrually dunno how to setup the rda. haha. but from researching, rda produce clouds of vapor. haha. soo, any advice? sorry. first time buying one. wanna quit smoking. wasting to much money.
DS is better in term of build quality. if comparing between the two options u gave, personally i think k100 is better. as for era clone and rda, i have tried both and prefer era clone compared to the latter. reason? its top cap is more tight, almost no leaking, and seems more powerful (firing) than rda. im still using my rda though cos dunwan waste money buy another dripper
QUOTE(slimfox @ May 24 2013, 02:17 AM)
Guys just bough a AGA-t tank. Any advise on how to stop it leaking in the combustion chamber? My setup smokes very well its just that lots of juice will end up in the upper chamber after a few puffs. I figured its either leaking via the mesh wick or the center hole of the wick. any advise?
hmm, u closed the refill hole ady? if yes then most probably its leaking from the wick hole. im still experiencing this with my aga t only thing i can reduce the leaking is by making the mesh a little bit fatter to fit nicely in the wick hole.
QUOTE(donatelo @ May 24 2013, 10:52 PM)
hi guys, i just bought KTS, after a while firing button start to hot, any sifu got solution for this?
@ekudz can u pm me where u bought e-liquid ingredient?
i would like to try make some e-liquid too.
either u sand down the firing pin at the point where it touches battery pole inside, or apply some noalax. a lot of people experience this including DS mod users. if u want to sand, use sand paper till u can see brass color underneath it. dont sand too much else it wont touch battery pole.