wta, the GA at bts still at 7th floor?
need to get some line marker n etc.

need some tips as well. i realise when i cut the parts out, it left a quite un-nice scar on the plastic, which is quite fugly. how do you guys normally cut the parts out without damaging the kit too much?

i screwed up my MG Destiny extreme blast mode. i tried to apply the flat top coat, then after a while, i see the whole unit turning white (like kena a lot of snow) and the white is not balance. I dont know what to do and panic, tried to wash those white area with thinner. it can come off then i start to become lazy and pour thinner into a pail, and soak the whole gundam it is and take it out. now almost all those plastic joins are breaking off. . I think i have to buy a new unit because buying parts for all those joins won't be cheap..

Hi guys...for those who wants to increase their detolf cabient capacity, there are these cool folks in the LYN Aircraft Modelling Thread that has a very good and ingenious method...

Go check it out...good idea to fit more 1/100 and 1/144 scale kits...

http://forum.lowyat.net/topic/210068/+1420



Some details here...credits to songscm, hkshim and blu3hamm3r

I bet u wanna own this

aiks...just placed order on the MG version..

The glass you need to cut your own so really depends on which shop you quoted from but from that thread, it shouldn't exceed RM6 per piece..

The nuts I do not know...i saw before in a rather expensive hardware shop, got 4 nuts like RM13.80, and i think that is for bigger size one...can get cheaper for sure if look around...

In any case, the height is customizable to your own desire and definitely cheaper than owning another detolf...

Colour, weapons and decals. Other than that its the same with zaku 2.0.

Ic ic... It's just that I thought the photo of the person holding the MG Zaku II box on the previous page is Tiger I. 
Ok.. ok, ignore my statement guys..   

whenever a part is broken n glued back together (regardless of whatever u uses be it super glue, cement, etc) will never be as strong as when its a single piece. For instance if u sand a very small piece that is glued together u cant apply the same force as if it were a single piece, u hav to be gentle and light or it'll just break again at the same location. Ur question of strong enuf required context, strong enuf for what? Hold itself together sure no prob. Withstand rough handling, flexing, bending, etc nope.

ty shifu    but why it call NG ??

1/144 Norn & full armor unicorn!!

Yesterday was my birthday , and I don't know what present do I want. I want s3 mini ,but I want gundam too.
I don't know I should choose which one......

Differences between strike and freedom is ..strike has gold colour parts ? And freedom has no gold parts , am I correct ?