Hey I can achieve 357HTT with 512MB RAM without Vcore increase. But when I slot both memory my system beeps like hell....stupid DFI sometime it works sometime it wont. This is the most weird mobo I ever had

Been thinking of buying this TForce 6100 but I dont like microATX and two PCI slot will limits cooling for my gfx card since I use sound card and currently using Vantec Spectrum PCI fan card.

I like your motherboard,its more difficult while using 2 RAM expecially with 2 bank RAM.THis is NF4 chiupset problem.

btw, @thread starter, u alrady test its stability? really wanna noe.. coz its a f***'n high proc.... really really wanna noe wats its codin...

sound like jeles.. ..juz kidding..

StupidGuy did mentioned that he was running with 2x LDT multi.

That explains the high HTT speed, which enables him to run high speed overclocking.

On nForce3 (DFI 250Gb to be exact) I remember that the system refuse to load with 2x multi, while with 2.5x the overall Hypertransport speed is already exceeding its limit at 320MHz. I don't know with nForce4 S-754 because I have never experienced using it before, but this 6100 chipset is probably the reason of this such high overclocking.

errr... who...

I also want to know the stepping.

weirdly enough

i was running 3x at 330+ on my nf4-4x

cant run at 2x?

2x is possible , but why 2x when i can run it at 3x ?

was it prime stable more than 8 hours?

I'm running 3x at 338 on my nF3 prime stable for more than 12hours, 2.5x will do fine as well.... but no go with 2x

2x will help better stability

the rule of thumb is to make sure HT speed doesnot exceed 800mhz, but slightly more wont hurt

well

didnt bother priming it

but fragging for 12 hours was no prob , all i ned is a good gaming pc

haha....better prime it for stability bro.....

will do when i get it to work again

got noob question need to ask u guys,

289 x 9 = 2600mhz & 325 x 8 = 2600 mhz

which 1 will performe better? stability? performance? gaming?

which 1 is faster?

higher ram fsb gives better result

in gaming performance? and other things also?

nothing to do with multiplier?

Theoretically.... if both had the same RAM speed and timing, there will be no difference at all. This is because K8 HTT does not work the same way as conventional FSB. No matter what divider you use including 1:1 ... the CPU and the memory will always be on divider, so bottleneck issue is not a concern. Unless you can run the RAM at the same clockspeed as the processor, then it is really a perfect bus efficiency.

So, referring to your options, any will do, but try to use RAM divider which allows higher speed.

Nice OC. Biostar sure does instil pride in mATX owners.