i need serious help here! E398 + MR3420 V2.. why does it keep disconnecting??? is there any setting in V2 that we have to change??? i already changed for it to connect manually and set it to 0 so that it will remain active.. but still.. when i got up in the morning, the e398 already blinking..     

and sometimes, the V2 cannot identify e398? it says identifying.. when i reboot then its ok.. but then after several hours it keeps getting the same problems..     

You using it with your old E398 or new E398

Please remove the old bin file and factory reset your router

u need to select Option : Connecting automatic  and set 0 to IDLE 

[attachmentid=3203639]

make sure your V2 is update to latest firmware too, mr3420v2_en_3_13_27_up(120905).bin

[attachmentid=3203641]

your E398 is old or new ? or rebrand K5005 set ? 

please download this bin file

http://www.tp-link.com/Resources/software/...0_v2_120703.zip

the latest one not totally working at all for e398.

after download,please extract to one folder,then upgrade your firmware.

after finish, it will reboot and try to disconnect your e398 and turn off a while...after that turn on, wait the all LED stable..after that try connect again your e398.

try to monitor your status at page 192.168.0.1

hope this can help u.

***it will take about 3 minutes to connect the net

thank you 

but signal still shows 0% for E372 rite ?

I got a new firmware

This is for E398

http://www.mediafire.com/?k4wyu2bsuwg7d0c

No need BIN file anymore

---

Added on December 26, 2012, 10:43 am
Totally okay