CPU: AMD Sempron 2800+
STEPPING: LBBWE 0527 EPAW
SPEED: 2704MHz (338MHz x 8)
VOLTAGE APPLIED: 1.63V
COOLING: AIR

MOTHERBOARD: DFI LANParty UT nF3 250Gb
RAM: 512MBx1 OCZ EL Platinum Rev2 1.1
DIVIDER: 5/6
RAM TIMING: 2.5-4-3-10 @ 1T
RAM VOLTAGE: 2.8V

POWER SUPPLY: Enermax FMA EG465P-VE 460W
CPU COOLER: Thermalright XP-90 with Thermaltake UFO fan

a new one ....

8 hours prime stable

don't forget your stepping ya.... i'll replace your old result with the new one.

lichyetan, the screenshot does not show any stepping info. cpu-z only shows the core revision, not the stepping.

the only way to read the stepping is by looking on top of the processor.

err.... your sis knew that u oc her pc ka?

goldfries : hardly understand the prime you're running

what's your bios set vcore? i'll update later on

didn't saw

i wonder where's jslut....

you already answered yourself

i think screenie image link dead already... pic is not displaying

how come watercooling only 2.24ghz? that's low man....

I'm not really familiar with your RAM characteristic.... what is it originally rated at?

Anyway...try this....

DRAM Frequency Set - 150 (DRAM/FSB:3/04)

Command Per Clock (CPC) - Enable
CAS Latency Control (Tcl) - 2.5
RAS# to CAS# delay (Trcd) - 03 Bus Clocks
Min RAS# active time (Tras) - 07 Bus Clocks
Row precharge time (Trp) - 03 Bus Clocks
Row Cycle time (Trc) - AUTO
Row refresh cyc time (Trfc) - AUTO
Row to Row delay (Trrd) - AUTO
Write recovery time (Twr) - AUTO
Write to Read delay (Twtr) - AUTO
Read to Write delay (Trwt) - AUTO
Refresh Period (Tref) - AUTO
Write CAS Latency (Twcl) - AUTO
DRAM Bank Interleave - Enabled

DQS Skew Control - Auto
DQS Skew Value - 0
DRAM Drive Strength - AUTO
Max Async Latency - 8.0 Nano Seconds
Read Preamble Time - 6.0 Nano Seconds
IdleCycle Limit - 016 Cycles
Dynamic Counter - Disable
R/W Queue Bypass - AUTO
Bypass Max - AUTO
32 Byte Granularity - Disable

LDT multi = 2.5x

if cannot use 150 divider, use 133