Welcome Guest ( Log In | Register )

Outline · [ Standard ] · Linear+

 Repraps and DIY 3D Printing!, Open source hardware~

views
     
blazinstreaks
post May 6 2012, 10:48 PM

New Member
*
Junior Member
10 posts

Joined: May 2006
From: JB-Melaka
I had attempted to build a RepStrap printer weeks ago using mainly locally available parts, except for the stepper motors (USA) and bearings (China). Total cost around RM700~RM800 (excluding the printing material).

It took me a few months to read up on the mechanical and electronic modifications since it's not from main Reprap branch. Still working out the programming kinks. The firmware isn't moving the motors properly as they should.

This post has been edited by blazinstreaks: May 6 2012, 11:11 PM

 

Change to:
| Lo-Fi Version
0.0715sec    0.36    7 queries    GZIP Disabled
Time is now: 29th March 2024 - 11:11 PM