I've been using cap ayam for many years on all my cars, including twice on my Sabby since I bought it. Yesterday, found out I ran out of stock, also unable to obtain from  supplier. So, out of desperate I asked magician opinion, and this is what he got me. He was saying, car so damn old liao, use what semi/synthetic oso no use lar, sure eat oil liao. Then I ma ask him proceed lor. Labor+oil+filter all together RM60. In my opinion, quite reasonable lar, but the trouble is....

Yesterday after oil changed, I did about 200km. Engine noise seems reduced, may be placebo but I believe new oil give better lubrication. Performance wise, doesn't seems to have any difference from my previous capayam 15w40. As my car reaching 350km on the clock, fuel warning indicator already start blinking So I went full tank at about 380km. To my surprise, it still drank 28.7litres(normally 28 litres I'm already at 400km) Today, 1st box on the fuel indicator gone at 29km!!!!! OMFG! I was filling to the brim, and normally my 1st box will only be gone by >50km Didn't know different oil can have that significant on FC

Magician said EFL is Renault's preferred oil, that's why I took it. Now I felt a lil regret on it though

So glad to hear that Regarding loudness, it has to couple with proper intake system only will sound nais Have you mod your intake?

Since you're wondering, so here's a video for you. I purposely drag my daughter to conduct this experiment for you, at the same time I can educate her



Can you see the difference? With and without swirl. However, those bits that use to twist the air flow were meant for noise absorbency, therefore at the same time you're getting a better noise reduction(which is not exactly what you want ). If you want loud noise, just remove the centre bullet, go and twist a pipe and weld it on Last but not least, the rear tip weld a trumpet tip your exhaust sound will be amplified together with the swirl flow, next time before you reach roadblock the fuzz ady waiting to collect ady

Manual ar? Clutch pedal press to the bottom liao also very hard to shift in, need to release repress kaw kaw baru can shift in ka?

fan install in air filter hose

What did you use to clean throttle body? And mind if I ask what happen to your mom's Persona clutch? Since I have one too.

Didn't know AMT robotic arm need to calibrate before start car No wonder you say when crank the shift indicator goes to 3/4 That probably because shift not in the right place when bat3 not enough to recalibrate
f***ing impressive
no, but depends whether your bat3 magician sohigh enough to offer you higher price
Metal clicking sound is definitely BEARING problem. It has nothing to do with the cabin receiver/blower fan, because the blower fan is running on ELECTRIC, has nothing to do with your gas pedal input. So, the entire aircond system, only place came with bearing is the aircond compressor



New compressor RM1200
New compressor clutch kit RM320
Evaporator filter RM20
Full gas R134 RM120

Reconditioned unit RM400
Clutch kit, recycle old 1 - FOC
Evaporator filter RM20
Full gas R134 RM120

You do the maths

My all time favorite aircond guy is located in Puchong Taman Kirara. All my cars send there for checkup and repair in regards of aircond system. Price reasonable, and boss Ah Yap will explain every single detail before repair/replace so you know what and why you need to spend on.

YKS aircond services
[Maxis2]36964[double5]
Let me know if you buy, we share. Same problem here, same side also



http://www.lelong.com.my/full-set-high-qua...7-01-Sale-I.htm