Outline ·
[ Standard ] ·
Linear+
Unifi TP-Link TL-WR1043ND, with Custom Unifi firmware
|
steventan85
|
 Sep 5 2012, 09:38 AM
|
|
can i set a quota for each MAC address assigned on this TP link address ? is it possible ? i know we can set a max. speed for each IP / MAC address, but can we set a quota like 10gb ? http://www.gargoyle-router.com/ ... if i flash to this firmware , will i have difficulty in vlan tagging ? i juz need unifi for broadband , IPTV and others is not important for me.....any advise ? This post has been edited by steventan85: Sep 5 2012, 09:54 AM |
|
|
|
|
|
steventan85
|
Sep 5 2012, 10:38 AM
|
|
|
QUOTE(kenjixx @ Sep 5 2012, 10:26 AM) after you use gargoyle firmware it's still possible to do vlan tagging you will need to modify the vlan through WinSCP because there's no vlan tagging setting in gargoyle i try that before but has been revert back to openwrt  sorry i can explain well in this ..well not really good in this kind of stuff what if i do not want to do vlan tagging , will it affect my unifi broadband ? i juz concern on broadband only... openwrt can't do quota management right ?  |
|
|
|
|
|
steventan85
|
Sep 5 2012, 10:54 AM
|
|
|
QUOTE(kenjixx @ Sep 5 2012, 10:50 AM) if you are using this router to connect to internet, then vlan tagging is a must unless you already untag the vlan on your BTU. well i found someone mention it's possible, just for you information. that will be troublesome... any router comes with quota management by itslf? |
|
|
|
|
Quote
0.0146sec
0.15
7 queries
GZIP Disabled