Welcome Guest ( Log In | Register )

Outline · [ Standard ] · Linear+

Unifi TP-Link TL-WR1043ND, with Custom Unifi firmware

views
     
ee7han
post Jun 26 2014, 11:19 PM

Casual
***
Junior Member
317 posts

Joined: Jan 2008
From: Your Face.

QUOTE(ysc @ May 11 2014, 03:07 PM)
Currently running Open WRT 10.03.1 and it's been running perfect (unifi 5mbps)

Internet is at max speed and WiFi is pretty great
*
I'm running on the same version, same router, but after following KL Seet's setup guide, it seems router in unable to connect via WAN interface. Unable to connect to PPPoE. It seems the WAN port is disabled or so.. Username and password is correct, setup follow exactly the same as KL Seet's guide.... icon_question.gif icon_question.gif
ee7han
post Jun 27 2014, 11:06 PM

Casual
***
Junior Member
317 posts

Joined: Jan 2008
From: Your Face.

QUOTE(blacktubi @ Jun 26 2014, 11:51 PM)
There was a bug where WAN port is disabled upon flashing on later HW version of 1043ND

Check OpenWRT WiKi
*
i bricked it while trying to reflash back to TP Link f/w last night cry.gif
ee7han
post Jun 27 2014, 11:11 PM

Casual
***
Junior Member
317 posts

Joined: Jan 2008
From: Your Face.

QUOTE(blacktubi @ Jun 26 2014, 11:51 PM)
There was a bug where WAN port is disabled upon flashing on later HW version of 1043ND

Check OpenWRT WiKi
*
I think i found the link with solution here: https://dev.openwrt.org/ticket/11898

Paste it here to help others with the same problem.

I bricked my router while trying to flash it back to original F/W to test the WAN port.

It behaves like a christmas tree now.

Power - LED ON
Initially - SYS, WLAN, USB, QSS - Flash once
Then - LAN 1 - 4, WAN - Flash once
(Then the cycle repeats)

Any luck with un-bricking my router??

This post has been edited by ee7han: Jun 27 2014, 11:19 PM

 

Change to:
| Lo-Fi Version
0.0233sec    0.63    7 queries    GZIP Disabled
Time is now: 1st December 2025 - 02:02 PM