We love Corsair cases! I have 2 Corsair Cases in the office and we recommend most customers to take Corsair cases if they wanted to go "steel". Corsair's sheet metal put CoolerMaster to shame, but then again, you do pay more for it. Well worth the money though

600T can only do push pull with low profile fans on the bottom of the rads i.e. Scythe slip stream

I will post my rig up after my RMA card comes back and after I added another GPU

650D has 2 usb 3.0 port in the front panel, but they use usb pass through

TQTQ I kaki also using one.

You can fit a 240mm rad on top but you have to move it off center otherwise it will likely be blocked by the mobo VRM heatsink.

800D can do push pull I have one more white 500R available if anybody wants to join the league

What sort of water cooling? AIO cooling like Corsair or custom WC loop? 600T/500R is not good for custom loop at all. You need 800D for that.

This post has been edited by CyntrixTech: Dec 9 2011, 02:10 AM

I can get you all the parts too

If you wish to use the 500R/600T/650D with Rasa RX 240 kit, you have to mount the rad off center by pushing it outwards a little otherwise it will hit the VRM heatsink. You can mount two 120mm fans inside of the top compartment but you may face some issues with not being able to close the grill depending on what fans you use.

If you wish to push pull, it may not be possible with any of the casings above other than the 800d. .

However, if you get the 650D/600T you can also order a Phobya 200mm rad for the front intake

OH BTW, the H100 can be used to hit 5ghz as well. If you cannot hit 5ghz with the H100, chances are your chip just won't do it

This post has been edited by CyntrixTech: Dec 9 2011, 03:03 AM

Another 600T:























This post has been edited by CyntrixTech: Dec 16 2011, 10:35 PM

Yup. Most of my customers end up with Corsair and G.Skill rams. Two of the highest quality products in the market with respectable prices:

Ram prices can be found here. Pictured are the 16gb Ripjwas Z CL9 DDR1600. This is the top selling 16gb kit at only RM4xx. The 8gb kit Ripjwas X is the top seller for 8gb
http://forum.lowyat.net/index.php?showtopic=2051436&hl

One of the best casings under RM300. Another one is the CM 690 II advanced, which is even more user friendly on watercooling.

You can mount a 240mm rad internally. Only certain radiators would be able to fit. Thick rads would not fit due to the mobo VRM heatsink blocking.

Little difference between them. Price different RM100

Corsair 400R

That's all that we got. Lazy to change lens and move the strobes too much

If you wish to view the interior, you can send the side panel to have a window made for RM70-80 (rough figure)

Was just suggesting the customer to cut out a window, we do not offer the modification service. Cutting out the bulged out area should be good. A recent forumer criticized that it's quite meaningless to have the interior looking beautiful and all when there's no window to look at it. So that's something the customer could consider. But most importantly, keeping the interior neat makes dusting the PC significantly easier. I use an industrial blower to clean PCs

We only sell/build complete rigs/parts.

Corsair 400R

People who buy 800D usually have rig around RM10k+. Don't have that many customers of that magnitude.