hi all,

how to set 2nd unifi using rb250gs?

1st unifi already set up n running fine...

Yes, I have 2 fiber connections at d same place.

D 1st 1 already using VLAN Tag 500, 2nd unifi uses 600 but firewall doesn't seem to b able to dial (pppoe)

Both use for different/separate traffic (controlled by firewall).

Just need to get d firewall to dial d 2nd unifi properly.

Y it couldn't do it ah? Some settings must b wrong here...

---

Added on February 3, 2012, 9:56 amI'm not using it for LB. Coz 2nd unifi has no fixed ip....


This post has been edited by MISMan: Feb 3 2012, 09:56 AM

Yes, 2 unifis in 1 place. 1 dyn IP for surfing, 1 static for emailing. No load balance (firewall does tat).

The static is already working. Dynamic account was just installed.

IF try2 still kenot, i'll do 2 rb250gs routers for fault tolerant....

---

Added on February 3, 2012, 10:07 amSorry, vlan 600 is not a retag. Vlan '600' was setup SIMPLY to differentiate from 500.

Can firewall dials '501'?


This post has been edited by MISMan: Feb 3 2012, 10:07 AM

Yes, correct.

I need rb250gs coz my FW couldn't dial directly.

It's a sonicwall tz200. It supports vlan tagging but still failed to dial directly.

My setup always concentrate on FW; thus making other equipments running in bridge mode.

been there, done tat. manufacturer said it could, but other Vendor couldn't make it work. some others said couldn't.

Ding ding dong dong, end up, got d rb250gs solved tat problem.

Next time, dun get sonicwall. Get Fortigate!

yes...all ports r configurable by software switches. I wonder if d vendor has tried tat. They exhausted all methods...

But, it is possible to do it tat way...have to fiddle FW to try...

i hav 4 wan ports (all ports r configurable). I can set any lan/wan combinations.

I tot i must add vlan tags instead of striping it???

later i take a snapshot of my existing rb250gs pics to show u...

hey guys,

would u guys take a look at my rb250gs config to c wat's wrong?

Vlan:


Vlans:


Problem is, tz200 couldn't dial pppoe properly for WAN2. RB250gs constantly switching from Port 1, 3 to Port 2,4. Can tell from d way LEDs blinking.

Port 1 (from tm 1st unifi) couples with Port 3 (outgoing to FW as WAN1) works perfectly. After adding Port 2 (from tm 2nd unifi) couples with Port 4 (outgoing to FW as WAN2); it didn't work properly.

Any idea? Any other important settings i over looked?

How ler, here's my 'forwarding' page:


Sorry, dun understand d cross connection part. Dun understand how mikrotik put up their routing table either ...

Any help is much appreciated!


After viewing post #4, i think it makes sense now.

This post has been edited by MISMan: Feb 3 2012, 05:09 PM

I know. Tat's y i find it very strange. Wat looks like a 'routing table' is a port comm table. Weird.

Yes, i tot of getting 2 x rb250, for fault tolerant as well.

any mikrotik vendor here?

Looking for robust AP solution for internal & external guest users (hotspots service).

Best to have ldap integration, else radius oso can do.

A simple n reliable AP will do.

Thanks.