Outline ·
[ Standard ] ·
Linear+
>>**LYN Perodua MYVI Owners Club vNineTeen°°<<, ~It's a Passion~Lagi Power, Lagi Best~
|
bulldog2
|
 Nov 16 2011, 04:51 PM
|
New Member
|
OK got fed up with the rough gear change and rough engine sounds I finally dicided to Change to the 4 to 1 extractor center bullet and all 1.6 " SS piping... Guess what it was Fantastic!!!!!!and awesome !!! the car now launches to redline much easier and faster and also the kick down when hard accelarations now is so smooth.. rather than the old lag and drop 2 gears at times! ALl this was recommended by Kweng of the kakiexhaust in serdang and even though the extractor is a cap ayam one it did its job . Now since i already have voided the warranty.. I might as well continuew with the twin port front and disc brake rear conversion... Take a look at the picutred and look at the exhause manifold and the CAT ...all those are robbing us of the power it suppose to have. all the MYv's have the same exhaust configrations and that makes me wonder how did they put in an 1.3 ehaust system into a 1.5? MY boleh again? Attached thumbnail(s)
|
|
|
|
|
|
bulldog2
|
Nov 17 2011, 07:24 PM
|
New Member
|
QUOTE(ikiey @ Nov 16 2011, 05:00 PM) Wow Bro, if 4-1 on a manual i think its meant for top end power, but for auto its a bit diff... So, how much did u spent for all those mods...?? What about the warning light on the dials...?? So kweng will drill a new o2 sensor on the manifold izzit..?? Sound wise, must be louder rite...?? Not sure as the config for myvi due to space in the bonnet we need to use the 4-1 rather than a 4 2 1 spent around 430 for the entire setup as I kept the original silencer behind. Yes both the sensors were replaced and the extractor already come with sensor slot they had only to redo the one after the CAT. Quite as original or maybe even better now as I do not hear the engine struggling from the front compartment anemore and for the rear its the same as before as I have already done soundproffing at the rear and wheel wells. |
|
|
|
|
|
bulldog2
|
Nov 17 2011, 07:30 PM
|
New Member
|
QUOTE(MorningBoyz @ Nov 17 2011, 07:25 AM) monster in the making, put in a turbo kit soon? or maybe a supercharger XD not sure yet but I have been there done that read the book bought the t shirt n saw the movie so I guess I would be going all the way NA and see what I can pump out of this baby engines. at the end of the day its still the wifey whos drivin it so I cant really make a monster out of it! maybe just a ..........................................tad faster...  |
|
|
|
|
|
bulldog2
|
Nov 17 2011, 07:42 PM
|
New Member
|
QUOTE(ikiey @ Nov 17 2011, 07:36 PM) Waaaaaa, Bro, that really is good prize...! Sound wise, does it screams a bit..? As i know the CAT is the 1 that restrict a lot of air flow...? N u already put in drop-in K&N rite..., so u have almost like free flowing exhaust n intake system already... yes the reason this guys are cheap is because they r doing the dell way B to C so thay can get the product to the market faster and cheaper. yes K&N drop in is in and the flow now is very smooth and quicker and this is what I was looking for but how I wish now I can push the gear change to 6500 or 7000 rather than 6000 muhahahahaha!!! but then again the new car aint no have OD and its a auto  |
|
|
|
|
Quote
0.0414sec
0.72
7 queries
GZIP Disabled