Male and female molex are sold right? What about the 24pin socket on the motherboard? I need it for my extension so that i can plug that socket to the 24pin power cable.

I want to go UV but Silverstone's PSU will have the warranty voided if the already sleeved cables gets resleeved.

Where's the intake fan on your casing?
Better put it up, or else your system will be choked from fresh air liew.

PCIE cable, i don't know work or not, akachester is it u using Lian Li pc-7
? I don't know the PCI-E cable enought u to hide through behind the HDD case and come out from middle of the HDD case there. My case can't XD because no space at the back.

Go BTX and lots of issue would be solver naturally ....

for the hdd u can try change the direction,,make it the cable mount the other side..so can invisible abit ur cable,,erm for atx cable i think i can b hidden by made sum hole on the mobo tray then u can plug it direct under the mobo..for me also its wud b nice if u let the psu fan face the other side..then it will make the cable abit longer coz the cable from psu will b abit top rather than now at bottom..n yeah 4pin/8pin atx power also need to make hole for ur mobo tray..but if the lenght can direct plug when route behind the mobo then no need to make hole the other cable for power switch,reset and so on u can try sleeve it or route it properly by cable tie it..then it wont b messy jus my opinion

@akachester

I think it's fine current cable management outcome....

I've posted some tips at Lian Li thread ... lazy to type all over again ...

Ultimate solution BTX !!!!!!!!

hahah, u are giving preview arr ???

Faster post your rig dude ...

hehehe .. finally the long awaiting A10 is arrived with awesome setup ..

So far so good ... looks good ..

btw, can't u route the 8 pins mobo connector behind the side patent fan ..

I did mine last time by routing through the opening between the mobo and graphic card ... then straight up to the connector ..

not sure ur setup can do the same or not ...

thanks. spiral sata thingy is the basic idea of cable management yet i didn't know. copy from my friend then later switch the hdd front-to-back, better. but a bit difficult. need to plug in sata n power cable 1st, then only put both hdd into the bay

anyway, yours aren't bad either. btw, those cables cannot go through behind mobo tray? im sure you still not satisfy with that

if u see my cables i didnt bother using the holes near the sata ports.... as i want my mobo tray to be easily removable. but then again the sata cables are easy to remove so no big deal. easier to remove then routing the cables between the PCIe and mobo.

extension cable... i strongly suggest u take a trip to jalan pasar (i know ur young...so bring thy daddy). they would have all u need there (except cable sleeves). once u have all the parts, either make it ur own (usually involves crimping the pins with the cables) else, if ur not competent with a soldering iron, find someone who is. some of the shops in Japan Pasar might even be able to make it for u on the spot. so make sure u have all ur measurements ready.

u need the male and female molex, male and female pins for the molex and of course the necessary cables. heatshrinks...not sure.

also, u could try and ask some of the bulkers for the Silverstone PP04 though im sure the price will be more than a trip to Jalan Pasar

btw, u already have the A2 soundcard. why are u using the Asus PCIe soundcard??

This is what I did last time for graphic card

Cost me less than RM5 to get it complete .. .

So just try to get the right connector, pin, wires and it could be done with a crimp ... btw .. could get industrial heat shrink at the shop as well .. very cheap only ..

remember.. thats with modularised cables