Since you've already bought it, use it... Gains very minimal, but it's a gain as well.

hmm...   
hmm....    

high cam already install d.. not really high la.. more towards mild cam.. d idle also not much different unless when air cond kicks in.. d idle will go 600-700rpm... then starts burp burp burp... ask foreman to adjust aircon idle, he say think my ufo diaphgram rosak liao..cannot adjust..zzz..

already took d ultra racing crankpulley.. khguan explain really poison.. say this 1 better than chaplang coz heavier, so wont have belt or oil seal / bearin pecah.. mayb i go install tomolo..see he free or not..

jus installed ligthen crank pulley... thanks to khguan from ea autoworks for all  his hardworks...lol.. vry difficult to install..somemore need change compressor belt..

1st impresssion is, installin K&N drop in filter has much more pick up power than this.. well, this is based on feelin alone..lol

need more time to notice more...

any spare part  shop in puchong recommend or not, coz everytime my car go through those pole hole, the door sure give some "mouse" sound lolz, we have to change the rubber and the metal thing?..

My fuel pedal does to....but...it has moodz

sometime do, sometime don'ts

interesting piece of car

ngek ngek is caused by the linkages/hinges of the pedal. take WD40 with the long red tube, and try and aim and spray around the pedal from under the driver footwell area. should be ok after that. if not inspect the clutch cable and if sound is from there time to change i think it's around RM40 for the original.

Ok will try to do that... Thx

looks like people here are convinced that rim upgrade wouldnt increase the FC? especially considering:

13" 2x OEM sport rim (came when purchased car back in 1999) front, 2x steel rim (sport rim stolen, bad day )
- assuming may be heavier than the new sport rims?
- what are oem 13" sport rim weights anwyays? anyone know?

upgrade to

hi my iswara head lamp pecah due to some stone. How much is the market pricing selling outside, ori one.
It is easy to change DIY? my area is around pj klang shah alam. Or you guys any shop can change for me also can.
Lastly my number plate is fainting. How much and where can find the replacement? Mine is just painted on the pate only.

Thanks.

Got meh? Where to find... I've been searching all over but only got for Wira onwards...

anyone can confirm my open pod setup here..
i plan to DIY..
CARBURATOR RAM PIPE > PIPE > FILTER

correct right ?

mau i got lobang direct custom made headlamp lobang 

---

Added on October 24, 2011, 11:01 pm

hello to all sifus here.
im about to get my dad's old iswara (1994) in a few weeks time. i want to ask, what are the things that need to be chleck or replaced so that i can use it to travel long distance with less risk of breakdown. is it still possible to travel at 100-110km/h when at the highway?

any advice really appreciated. me still newbie with car. =)

thanks guys    will take my time to check all those things.
do i need to pay any special attention to the engine or just change the engine oil and filter when the time comes?

no jerking issue at all.