Wow notoriez so cheap ah? During early 2007, I still remembered being charged for almost RM300++ only for painting the bumper + driver side fender. Paint only. Haiz....
@piecereborn: try checking your door hinges, or your rear seat lock behind the seat. Usually if bunyi tikus caused by that lock behind the seat. Wrap it with some rubber tape then that should be fine.

erm... I can't interpret how's the sound la. Can explain more? When it happens? High speed? Or when drive at bumpy roads?

"eeeee" as eeeekkkkkkkkkk @ eeeeetttttttttt ?

you sure the noise came from front seat? not rear seat?

If radio and air conditioner turn on/off automatically means what ah? My friend ask me. I also duno

your spark plug still ok? you did any mod to your car recently? maybe need to retune your carb..

---

Added on July 1, 2011, 7:49 pmslipping sound? or detonation? if sounded like sew machine maybe need to adjust your distributor a bit.


This post has been edited by fleekreturn: Jul 1 2011, 07:49 PM

Sound is major prob of our car. Haha

front speaker is a must for better entertainment~

Yeap. That's normal n good. Keep it up that way~ Btw, recently my a/c prob. The aircond fan at engine bay there not moving at all. Maybe fuse, relay or the fan motor prob. Any idea guys?

Today just fixed my a/c. Condenser fan not moving. Total damage, RM1+- Changed the fuse only then everything went ok back.

If engine oil leak try to source what the problem is. If ur exhaust got white smoke, try replacing the valve seal. Could be one of the problem that caused the oil to leak. For the belting issue, just tighten back the belting and spray some WD40. Should be ok then.

Easy or not to open the plastic radiator clip at the bottom there? Mine a bit tight. Scare the clip will patah if I use force to open it.

Opening that clip is enough to flush the water out right? Will try out tomorrow morning~

The clip just pull out or need to twist? I'm not sure it's the socket or etc. All I know is that the clip is located at the bottom of the radiator there.

Ok tq sky.. Lyrodson use open pod lo if want fierce sound.. Or if you wan fiercer, make custom piping where the exhaust is located below the gear console there.

same thing happened to me couple weeks ago. I just changed the fuse for the fan only. Previous fuse melt d.. Cost should be less than RM2. Try those simple thing first. Fuse, relay.

Some said the ratio of 4g13 n 4g15 gearbox is different. I'm not sure. Newbies. Btw, I've converted my 4g15p from auto trans to manual trans. The manual gearbox came from a 4g13 lmst car. My ratio now shown as below:
3000rpm - 100km/h
3500-3600rpm - 120km/h
5200rpm - 170 km/h
5500rpm - 180 km/h

Hope it helps. Btw if you changed to a bigger size of rim, your speedo meter will not be accurate anymore. As the rotation mass of the tire has changed.

this one I'm not sure. later I'll check either using vrac or vrbe gearbox.


I'm using 175/70/13. Btw, total weight of current rim + 175/70 tire = 11-12kg. Kinda heavy I think. September will change to 15" lightweight series rim~

I experienced once before. During daytime I can't notice. Until when I go jalan2 with my friend. He ride his car and he saw white smoke coming out from my exhaust. I just change the valve seal and no more white smoke. Don't know your case same or not..

wah the price.. I kena RM120-140 nee for changing the seal. Include workmanship~

I kena RM70 for 1 bearing + workmanship. Sob2.

Ya ST clutch will improve pickup, but then it depends on how well you skim the flywheel because as I recall, if the flywheel is skimmed too light, you will only gain pickup but your top speed will suffer. So need a proper balanced skimmed flywheel. ST clutch still in my to-do-list btw. Haven't done it yet.