Hi guys, im using OCZ EL PLATINUM DDR400 512mb x2. The highest i can get is 280mhz using 2.7v with my Abit KN8 Ultra mobo using nf4 ultra.
TCCD/TCC5 discussions, memory tuning, voltage, etc.
|
|
 Jun 9 2007, 07:42 PM
Return to original view | Post
#1
|
 
Senior Member
6,744 posts Joined: Jan 2003 From: World Wide Web Status: Banned   
|
|
Quote|
|
Jun 19 2007, 05:37 PM
Return to original view | Post
#2
|
|
Senior Member
6,744 posts Joined: Jan 2003 From: World Wide Web Status: Banned
|
QUOTE(satanhead2003 @ Jun 17 2007, 02:24 PM) I think, u dont want your TCCD exceeding 2.8v. And, in my exp., i havent met any tccd will do CL3. Resulting in no-boot. n oso from my exp, tightening TCCD sub-timing will benefit little gain in perf. Unless it can boot with " Bank-Interleave" option as ENABLED in bios, then it will be in the same league as BH5 / CH5 / BH6 (of course w/ higher frequency than the later). My TCCD can use CL3 no problem with higher mhz compared to cl2.5. The tightest sub-timing of TCCD can give me around 29s in superpi 1M ( thats at oced to ddr600). n The tightest BH5 (yeah, Team Zeus Series) comes at 27s (oced to ddr500 only). Both at same config,same setup; 3G Opty 146.   |
|
|
Jun 19 2007, 10:49 PM
Return to original view | Post
#3
|
|
Senior Member
6,744 posts Joined: Jan 2003 From: World Wide Web Status: Banned
|
Owh, will do so. But currently folding, cant stop coz i need the points. LOL
|
| Change to: |  0.0233sec
 0.36
 7 queries
 GZIP Disabled
Time is now: 1st December 2025 - 12:57 AM |
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Powered by Invision Power Board © 2025 IPS, Inc.