Hi, I'm a newbie at OC. Need some help with my rig.
I achieved 3.71(413x9)G at vcore 1.3v for E8400 with RAM latency at 5-5-5-15, vRam 2.0v. However, i can't go pass 413 for my CPU even if i lowered the multiplier to 6. Tried increased vMCH +0.1, or CPU VTT +0.1v but to no avail as well. System stable with temp at load 52-53oC. Please advice how to increase the FSB of my CPU. I read about my cpu- it can go for 520-530 for FSB. Thanks.

My specs is in my signature. Thank you. (PCI E set at 100)

This post has been edited by lim5659: Sep 5 2008, 06:27 PM

thanks tkh. My RAM is Kingston HyperX DDR2-6400 2G kit(5-5-5-15)--> regretted. I will try to increase the vdimm and see. and of course lower the vMCH and VTT. Would increasing PCI E help?(101-105)

---

Added on September 5, 2008, 7:13 pmMy stock vMCH is 1.1v, CPU VTT is 1.2v. It doesn't work with increasing the vdimm to 2.1v. Got anything to do with MCH frequency latch, or SPD? I set it at 400Mhz for strapping and 2.0B (2x333) for SPD. It doesn't work with 2.0D (2x400). Thanks again.

This post has been edited by lim5659: Sep 5 2008, 07:14 PM

yes. ratio 1:1. i put my PCI E at stock 100. Could it be the strapping and SPD? Thanks bro.



This post has been edited by lim5659: Sep 5 2008, 07:22 PM

Need some advice. I'm switching my EP43-DS3L mobo for another board because the gigabyte board has poor overclockability. I'm thinking of getting a Asus P5Q mobo. Is it good for OC? Thanks in advance.