hi guys, what tools do we use to make a hole for the tap on a stainless steel sink?
I had one installed but no hole for the tap. Not possible to bring it back to the shop to do the hole dy..

Noted. anyway, i had bought a tools from IKEA to open a sink hole. Not that expensive though. Will try it out with that first.

Thanks

Forgotten the brand, its not a big brand. we forget to ask the shop to open the hole, and the contractor did the piping under the sink, so the water inlet is not on the wall.

Anyway, i had used the Ikea sink hole opener tools to open a hole on a sink.
It was easy and the hole looks as nice.

Sure, this is the tool that i used. Need to drill a 1CM hole first to fit in the big screw of the cutter. after that, just use a wrench to tighten the nut until it cuts the hole.

http://www.ikea.com/my/en/catalog/products/90176820/