Apr 19 2019, 12:31 PM
QUOTE(yop da great @ Feb 26 2019, 09:26 AM)
Are there official routing rules? I only know:
1. cannot run too close to power cables in parallel. How close I'm not sure.
2. Never bend smaller than the bend radius of the cable. This is especially critical for solid copper cables because it might break.
3. When terminating, don't untwist the pairs more than necessary.
Any other rules? We can compile them as a guide.
If you follow IEEE standard,1. cannot run too close to power cables in parallel. How close I'm not sure.
2. Never bend smaller than the bend radius of the cable. This is especially critical for solid copper cables because it might break.
3. When terminating, don't untwist the pairs more than necessary.
Any other rules? We can compile them as a guide.
1) power run & network cable run in parallel should be 1 metre apart
2) bending radius at min 1 inch preferrably 2 inch
3) when terminating, untwisted should be limited within the plug
Quote
0.0236sec
0.76
7 queries
GZIP Disabled