Feb 15 2011, 11:21 PM
QUOTE(LeoLilieno @ Feb 15 2011, 10:38 PM)
Since they are using the existing copper line, it means that its not using the fibre optic then. In this case, its same as streamyx albeit higher capacity. Am I right?
it is fiber optics. from their exchange to your building. inside your building will be copper as per built.you might want to read here.
http://www.praibroadband.com/2010/11/tm-un...or-residential/
or here.
http://www.unifi.my/unifi/index.php?option...d=69&Itemid=218
I suggest that all new subscribers/subscribers-to-be to read first before signing anything. Otherwise, later all complaint like there's no tomorrow.
Added on February 15, 2011, 11:29 pm
QUOTE(deunan @ Feb 15 2011, 11:18 PM)
Hi Calvin
New Unifi-er.. Username deunan
Hi everyone..
My new DIR615 comes with 7.09 firmware. The option to change the PPPOE mode to Bridging Mode so that I can use my own custom-router is missing.
Tried to do away with DIR615 and use PFSense. I've tagged WAN interface with VLAN 500.. But the PFSense's PPPOE Dialler refuses to connect.. I tried to put in the PFSense WAN interface with the MAC address from DIR615's WAN interface (the one stated on the sticker underneath the D-Link) - No go.
The only thing I haven't tried is changing the password for my unifi access - "username@unifi". I've a feeling that the password for "username@unifi" which is hard-coded in the DIR615 is different than the one they emailed me.. Anyone knows how I can verify this? Can't risk changing it in the D-Link, I'd be lockout from the internet then..
Another option - downgrade the firmware to 7.05b. Should I ?
Even another option - junk it for a different router.. A bit pricey but am willing to consider.. Any recommendations?
Thank you guys!
I don't think that they would change the account password without telling you. They aren't supposed to anyway. You might want to check the modem/router's log? esp on PPPoE part.New Unifi-er.. Username deunan
Hi everyone..
My new DIR615 comes with 7.09 firmware. The option to change the PPPOE mode to Bridging Mode so that I can use my own custom-router is missing.
Tried to do away with DIR615 and use PFSense. I've tagged WAN interface with VLAN 500.. But the PFSense's PPPOE Dialler refuses to connect.. I tried to put in the PFSense WAN interface with the MAC address from DIR615's WAN interface (the one stated on the sticker underneath the D-Link) - No go.
The only thing I haven't tried is changing the password for my unifi access - "username@unifi". I've a feeling that the password for "username@unifi" which is hard-coded in the DIR615 is different than the one they emailed me.. Anyone knows how I can verify this? Can't risk changing it in the D-Link, I'd be lockout from the internet then..
Another option - downgrade the firmware to 7.05b. Should I ?
Even another option - junk it for a different router.. A bit pricey but am willing to consider.. Any recommendations?
Thank you guys!
I am not sure on bridging as I've thrown out that DIR-615 completely out of the picture. Thanks to the sifus, I'm satisfied with mikrotik now.
This post has been edited by boxsystem: Feb 15 2011, 11:29 PM
Quote
0.0708sec
0.51
8 queries
GZIP Disabled