guys, i'm very new to ram ocing and i am abit confuse about a few stuff.

i followed this setting

kingston kvr @1333mhz 9-9-9-24 1T | 1600mhz | 7-8-8-26-34-1T | 1.67v | 1.3v

but i didnt adjust the voltage since i dont know which is the voltage setting in my bios. the 1st voltage is the dram voltage right, then what is the second voltage?

i'm using asus m4n89td evo board.

errr. i need to see the writing on the dram chip is it. which means i have to take the dram out form the mobo.

in cpuz it states it's kingston.

i'm using amd 955 BE. i bump the multilier to 20 and leave the rest to the mobo to handle up till now.

i'm thinking of trying to see if i can get past the 4.0ghz barrier since when i try the system just reboots into default setting.

ok just took out my ram and it states there kingston all the way. both sticks.

used the setting and i used the same voltage as stated and the ram speed increase to 800mhz compare to 600 last time. is it good or bad?

so any starting vcore voltage? i am thinking of starting with 1.40 volts.