Vimc?
wht is tht?nb?
sos plz

Bro. That AIDA64 you use is for what?

Btw, I've been extremely busy these 2 days. I've been helping my brother to build his new rig; and my father to upgrade his

Now I'm jealous with my brother's new casing. He bought a new NZXT Lexa-S. Damn cool. Too bad I can't afford a decent casing now  

Btw, Specs as follows;

1055T
CM Hyper 212
MSI 790FX GD70 - ( This 1 bought 2nd hand from another LYN forumer )
8GB Kingston value RAM.

He asked me to help him OC his 1055T a little bit and so I OC'ed it to 3.2Ghz. Bump the Vcore to 1.4v.
Push the NB to 230Mhz and added 0.2v to the CPU-NB voltage.
Can't remember I OC'ed DDR3 to how many Mhz but its definitely higher than stock 1333Mhz   Stock Timing.
Have Primed it for 1.5 hours and everything seems fine. The CPU temp didn't even reach 50c. Damn the casing have good air circulation......And Hyper 212 is really good for tis price

Picture Below;
[attachmentid=2150291]

Hi guys .. noob here ... i'm just trying to learn in OC .. got confused a bit ... i want to know about my max FSB by increasing it by 10 until max ... so, no matter how i increase the FSB .. the idea is try to run at almost the same as stock speed rite? or i'm wrong?  ... then ...CPU/NB Freq should be set to auto or what? and HT Link speed also set to auto or set it with the same one with FSB? guide needed ... tq 

thanks for ur response bro but i still can't really understand about how to set everything at 2000Mhz ...  .. will try to continue googling before can start ocing ...  .. thanks again

hi guys .. after some googling and found this guide .. i've decided to give a try with 2 core and run Prime95 Small FFT for 10 minutes and the temp already 64C ...  .. is it safe to continue increasing the multi with that kindda temp? 

5. Set CPU fan to manual and full speed - Dunno how to set this

i believe at stock CCF is better but when u do push pull on the 212+ it should be better than CCF stock, CCF cannot do push pull plak

Bulldozer benchmarks leaked!!

is that an MSI board?

link from bit tech and asrock

too many news,so little confirmation...no matter,i want u all thuban when u guys buy BD

Just asking, what kind of FANS you ladies are using?
why you wanna use that kind of fan and are u ruuning of full blast or controlled by cpu or fan controller?

ive been keep changing casing fan since i know how to oc
From Gelid fans > SFLEX G > AVC 2800rpm > Nmb Mat 4000 rpm fans
this NMB MAT fans is great, now my temp LOWERED alot,max temp decreased 7 c but its hard to control and it sounds like my pc is going fly off
P.S> sorry for off topic lol