Hi there...maybe it is a bit late to ask now after this thread had been idle for so long...but i do have some queries when overclocking my X58 system...

as u see my rig below, with my good old i7 930 clocked at 3.5Ghz~~what do u think is the appropriate DRAM Voltage?

As according to CPU-Z, the ram should be capable of running at 1.65V, but when i tweak the RAM above 1.3000 V, the indicator turns yellow..and anything above 1.4V it shows purple/red indicator..therefore the DRAM voltage ended up at 1.3V @1600Mhz

The reason why i am asking this is becoz i have been experiencing blue screen problem kinda often~~i was wondering if it is due to the overclock i did on my system...

Hope to hear from you soon...

Thanks, but where can i locate the blue screen log?

finally get it...but seems like my error code is 00F4
whats does that mean?

thanks for the brilliant info given to me~~
i think i found out the problem~~it is an SSD related issue..
i have updated my Marvell firmware from 1.0.0.1034 to 1.2.0.1002 at the link below:-

http://www.asus.com/Motherboards/SABERTOOT...ort_Download_30

It has been 2 days since and i have not experienced any F4 BSOD problem~~until it happened again i shall post an update here..

I have also checked the performance of my SSD by using ATTO Bench, seems like it performed much better at the start of the test (more than doubled of performance) and stabler so far...a must have update for Sabertooth X58 user if you are using SSD

This post has been edited by terryble: Apr 2 2013, 12:04 AM

Just to follow up...more than a week after i updated the Marvell Driver and it runs stable now without any blue screen problem.. the update also improves small file reading speed significantly~

However, if u are having a 500mb+ read/write speed SSD (e.g. Kingston HyperX 3K), u cannot run it at max speed under X58's Marvell Controller