CPU Clock Ratio--------[21x]
BLK-----[201]
Cpu Uncore Frequency-------[20x][4006Mzh]
Cpu Clock Skew--------[0ps] 100ps
Spread Spectrum-------[disable]
PCI Frequency-------[104Mhz] 100mhz

Voltages! ----> for BCLK 200, there's no need to raise PCIE freq, QPI LL and ICH voltage. Since there's no bottleneck at all.
unless if u couldn't run it stable, then only up the IOH notch by notch
EVGA Vdroop Control------- [Without Vdroop]
Cpu Vcore---------[1.35v to 1.4] depends on cpu
Cpu VTT-------- [+200mV to 250] gosh 1.2+400mv is 1.6v
Cpu PLL Vcore-------[1.890v] auto 1.8v
IOH PLL Vcore--------[1.890v] auto 1.8v
QPI PLL Vcore------[1.400v] gosh too high. Auto 1.1v
DIMM Voltage--------[1.660v]
IOH Vcore---------[1.400v] gosh auto 1.1v
IOH/ICH I/O Voltage-------[1.650v] gosh auto 1.5v
ICH Vcore---------[1.250v] Auto 1.1v
VTT PWM Frequency-------[250 KHz]
CPU PWM Frequency------[800 KHz]
CPU Impedance--------[Less]
QPI Signal Compensation-----[Less]

Memory

Memory SPD-------[Standard]
Memory Control Setting-------[Enabled]
Memory Frequency---------[1333Mhz/2:10]
Target Memory Frequency 2013 MZH
Channel Interleave Setting-----[6 Way]
Rank Interleave Setting----[4 way]
Memory Low Gap-------[2GB] 1.5gb

TLC Setting-------[8]
TRCD Setting-------[8]
TRP Setting-------[8]
Tras Setting--------[24]
TRFC Setting-------[110] try 88
Command Rate-------[1T]

Cpu Feature
Intel Speedstep-------[Disabled]
Turbo Mode Function-----[Disabled]
CxE Function--------[Disabled]
Execute Disable Bit-----------[Disabled]
Virtualization Technology--------[Disabled]
Intel HT Technology---------[Enabled]
Active Processor Cores------[All]
QPI Control Settings-------[Enabled]
QPI Link Fast Mode-------[Enabled]
QPI Frequency Selection--------[4.800]