anyone can get over 240mhz with this bios? i cant ler....

how far you manage to get with D27 fire?

it's depend on your psu 3.3v rail.

I'm using acbel 450w, after modding, i manage to get 3.26v since the 3.3v rail reading is 3.3v

no dare to mod vdimm but dare to mod L12 ?

@ amok

which mod. bios you tried ? normally tictac's bios give lower momery bandwidth than merlin's one. have you try tictac's d27 fire 3D ? I cant get fsb over 230mhz....

sound like wire trick can give extra fsb, going to mod soon

@ amok

one question here, i wonder how you connect the wire for the L12 mod? going to mod soon but no idea about it

thanks for sharing,
btw,yours mod is based on tictac's way?

got 1 more question, just put the wire inside without coiling become a circle?

This post has been edited by gsan: Jun 25 2005, 01:42 PM

hey sifu,

cannot fit with my proc at all after i putting the wire.... cannot find a very very very thin wire la...

This post has been edited by gsan: Jun 25 2005, 08:59 PM

I tried with the wire inside the telephone line but it's too thick for me, cant fit with my proc at all afterwards.

tried too but it cannot fix the proc, no dare to give a little pressure on it, scare later the pin patah pula

i wonder why tictac didnt put L12 softmod into the D27 3Dfire? I cant get stable above 230fsb.

with others modd. bios like d26 Manta Rays XT or d26 merlin speed fire, i manage to get above 250mhz fsb easily. but for d27 3dfire, i cant even boot with 230mhz fsb. i've tried the L12 mod but it cant fit the proc since i couldnt find a very tiny wire. i'm using bh5 and feed with 3.6v stable at 250mhz @ 2-2-2-11.

I've the same problem as you, cant get 230fsb with d27 3dfire. but for others such as d27 taipan, d26 speed fire, d25 3dfire, i can get at least 250fsb.

Just did the L12 wire mod. Load optimised defaults in bios and I got 166mhz fsb. Havent push to higher fsb but in sandra memory benchmark, i got lower bandwidth.

Updated: Just flash to D27 3Dfire 1T and finally i got 252fsb. Will push higher soon

This post has been edited by gsan: Jul 9 2005, 11:35 AM

woow.... you run 265fsb, synchronous with your ram? have you did vdd mod?

anyone tried vdd pencil trick? could you show me the correct way to pencil it?

maybe due to your southbridge overheat... any cooler on it?

no people try vdd pencil trick?

1.7v, i tried with the vdd pencil trick, but measure with multimeter, the vdd voltage still same, no increase.