nice setup bro . but for some reason the cable tie on ur tube is a little off. IMO . why not just turn ur CPU block up side down? 

abt to ask.. the way i look at it, doesn't seems to have enough space for rad fan  how r u gonna fit it in later? .

may b u wanna consider, rad on the top of the casing  . 2 fan > casing >rad. but u need to cut a little rad hole on the top of ur casing or mayb not .

---

Added on October 27, 2010, 1:08 amso u wouldn't block the mobo with the fan  .

lets take this to the mod section ...

@holy,

where u put your 360 rad?

advise u dont use cable tie to tie your tube... ugly look.. let it natural bend or use some 45 or 90 fittings.

hey, we use same psu le... u sleeve it by MDPC?

that a drain port using DD's drain/fillport adapter

---

Added on October 27, 2010, 8:13 am

wah bro, wassup with cable ties...use the adapter 45s @ 90s to route the tube better..

@holy,

your casing can put 360 on top ka?? take a shot picture on that area pls!!

@owikh84, lichyetan ,

walao so serious ka?? but i think wont go below ambient temperature rite?
bcos cpu so hot...

this is another short test about 15min... prime95

[attachmentid=1855479]

how's the temp?

uikss hahah, kan comel tak de cable tie tu ....

@holy,

nice setup.... btw, u can turn your water block in order to have better routing tube...

and u put your fan on top of radiator?

no lo bro, sleeve psu cost much  ... btw, i like original  ..

---

Added on October 30, 2010, 12:51 pm@cheesycake

u have to post your rig here... not only discussion as this thread is dedicate for picture thread.

Yeah, approximately.