since some of u guys seems to maxed out the speed [cant go further] , so now try to tight the timing at that max speed...

for amd64 users, be patient when config the a64 tweaker..
then try memtest..

n good luck in finding the best Tras timing

1. dude, ram don have temp probe circuit, so theres no such thing as software to read temp..

but u can attach those external temp probes with 7-seg display.. someone sellin it in casing mod sect last time


2. bcoz amd64 have it own memory controller devider calculation.. im not sure how it works, but it won be exact ram fsb = htt x (133/200)

theres amd64 mem calc tool out there

pass 32M Pi

for 2-3-2-5 1T, thats spd rite?
juz try 3-4-3-7 n do ddr500++

the only u cant change thru a64 tweaker is CAS latency n command rate T
basically A64 optiobs r similar to the options in DFi memory options
juz it work like clockgen, where u test in window, n if its ok, than u apply in bios..
well, u can straight away set in bios, its about the same..
but the advantage of this tweaker is for those other mobo that dont have bios options like dfi

usually its CAS - TRCD - TRP - TRAS - T command rate
> 3 - 4 - 4 - 8 1T [follow cpu-z top->bottom]

but some ppl put it the other way round
> 8 - 4 - 4- 3 1T

either way, as long u identified the CAS n TRAS , u can go figure the other two no. in between

ok, since this is a KVR thread, anyone got 1x1gb kvr stick running?
aside from be-5 chip used, anyone encounter any other chips?

260?
http://forum.lowyat.net/index.php?act=Atta...=post&id=123045
its a pair of dt-d43
but its time to let it go

This post has been edited by e-jump: Jul 25 2006, 07:21 PM

either it reached limit or the ram heated up too hot
puting on heatspreader without a fan blowing it will make it hotter than without a heatspreader =__=