i think most of the terace would have max 350 to 400 sqft. normally for a horizontal powder coating, market price should be around RM11 and doors around RM16

if mild besi, deduct RM4 or 5

so, in your scenario = 350 X 11 =RM3850
Door = 56 * 16 = RM896
Total = RM4746

I would say the price is around that range

Rm4200 is not cheap at all........that's the market price for an establish shop....u can get less than 3k if you check around those malay SME business..i did mine less than tat.

hi guys...for the gate, the job done from a bumi Sme , the office in sentosa , klang..i forget the name ady..the contact number u can call is 014-6485648 ....i forgot the name..mayb u can give him my reference that im from setia alam just installed the gate....

i can 100% tell u tat those ppl charge u Rm250 above per sqft is defintely overcharging u based on the market rate...

u try to call this fella first, then let him advice you and explain to u only u compare......

---

Added on April 13, 2011, 12:24 pmforgot to add, tat guy did mention bout the diameter of the steel bar , but i forgot, but defintely is the standard 1...u can get his shop address and go compare it...
thanks

---

Added on April 13, 2011, 12:25 pmand i wil post my gate picture tomolo

---

Added on April 13, 2011, 12:30 pmjust to clarify something, my gate is actually made from the normal besi with the most standard thickness and with the stainless steel railing..
then after finish designing n burn the besi, they will send it to galvanize , after tat, they will sent it to powder coat...



This post has been edited by tyhuang: Apr 13 2011, 12:30 PM

my bad....i misread ur stainless steel....if stainless u canot ask him coz he not doing it...he give other ppl do....tat's y more expensive coz i got ask him b4...mine is the normal steel wit ppowder coat...sorry for the misunderstanding ....

he did the window grille oso of coz...but mine was done by a company called NewGate coz tat time is till dunno this guy...if i know earlier, sure it will b cheaper.

for this guy, based on the gate he install, actually he miscalculate the gate height by 1/2 inch - 1 inch.

if u look at the first photo below, on the left side, the gate abit shorter than the wall, even though abit angry but i still accept it lar cozjust minimal error and mainly i didnt really follow up wif him coz bz working...but if possible, when u engage him, u need to follow up coz when he built the frame and he will take this gate to test it in our house then only send to galvanize n coating...

---

Added on April 14, 2011, 9:43 ami read somewhere invisible grille is mainly for condo...i think not practical for landed....i guess the best would be no grille at all....but u know lar..asian ppl, every1 oso scare...

This post has been edited by tyhuang: Apr 14 2011, 09:43 AM