ask u guys.....

I have 2x512 hynix D43 KVR. I tested 1:1 up to 260fsb and it ran stable in memtest86 for hours. So i decided to up my cpu clock speed by using divider. I set FSB to 280, multi to 9 and divider 9/10. It did post but didnt boot into windows or memtest.

My vdimm is 2.8v, VID = 1.425 * 110% , vLDT = 1.4v , chipset = 1.8v....

any idea guys ?

I already know the answer......

D43 doesnt like divider. So i stick back to 260x9 = 2.34ghz. Vcore is 1.42v shown in smartguardian and cpuz. Rock stable !

Full load temp only 43C using stock HSF and even the original themal paste.

Impressive result you got there arj !

how much you bought ?

rev A03 also can ? Then i got an A03 then.....

Well , when i was cleaning the thermal pad on the chipset heatsink , i saw that mine can be modded to SLI although it is a rev A03.

Evogenix : Not until i have a pair of SLI cards.

Hope to see the results from you.

Btw, just to share with you guys. B4 i applied AS3 on the chipset , the temp is so high at 56C. After i applied AS3 onto it, the chipset temp dropped to 46C only. Big drop huh ?

aiks no thermostat la bro. According to the ITE it shows 10C drop.

But you must be patient enough for not destroying the square sponge.

Evogenix , with the 510-2 bios , do u have the Level 4 for the DRAM DATA DRIVE STRENGTH ? Mine shows up to LEVEL 3 only...

well , after tweaking for hours , i found better timings which doesnt kill the bandwidth to achieve 260fsb stable. The key is the Idle Cycle Limit.

here is my timings...

enabled
2
2
6
2
7
12
0
2
2
2
1168
Auto
Enabled
Increase
150
level 6
level 2
08.0
Fast
05.0
016cycles
Disable
16x
7x
disable

With this timings , i can even get 253fsb at 3.4vdimm.
Every DFI nf4 users out there pls share your timings....

One stick died already ? I'm sorry to hear that. I'm now enjoying my ram. Tweak tweak tweak and burn burn burn...hehehe...

remysix : Why dont you ask dinster for help ?

I strongly recommend you to reformat your hdd. I believe with a clean copy of windows and drivers will work better.

yeah i doubt your psu is giving u problem as i'm using a 20pin psu as well. Furthermore, your another stick should have the problem if the psu is the cause.

Thank you for the link kianwee.

Luckily i have no SLI cards. Just the RAM gives me heat.

ray99mond : Tweak it and post us some results.

Some said that by doing 1.5cas is more stable than 2cas.

Can you lower to 3.4vdimm for that 250fsb ? 3.5v seems to high for 250fsb.

What TREF are u using ? I suggest u to try 1168. It's best for my ram. Also set the Idle Cycle Limit to 016cycles. This is best for UTT and BH5 ram. You might be able to do with 3.4vdimm after setting these.

gavlim COD in penang mah....