Outline ·
[ Standard ] ·
Linear+
[Impression] FiiO E7, Warning: lot of pics!!!
|
jigon
|
 May 28 2010, 10:07 AM
|
|
QUOTE(iv'N @ May 28 2010, 12:49 AM) So when lets say, if I start my E7.. and set USB Charge to Off.. does the E7 run from batt or run directly from usb power without passing the battery? After hours of usage, I notice the battery status reduced by 1 bar. e7 should be run from battery when the USB Charge is set to Off.. i assume the reason behind this is not to drain the notebook/netbook battery So far, my verdict : 1. notebook -> FiiO E7 -> ATH ESW9   2. Sansa Clip 4G V1 -> FiiO E7 -> ATH ESW9  Cheers |
|
|
|
|
|
jigon
|
May 28 2010, 10:32 AM
|
|
|
QUOTE(chingwooi @ May 28 2010, 10:16 AM) what's the resistance of the ESW9 again? i think it's on the lower side..less than 50 ohm.. Cheers |
|
|
|
|
|
jigon
|
May 28 2010, 12:22 PM
|
|
|
QUOTE(Bonchi @ May 28 2010, 11:47 AM) meh.. the volume on sansa clip is very very soft to begin with depends on your headphone impedance..mine is 10 click below the max volume is the highest volume i can bear.. more than that i'll turn deaf  Cheers |
|
|
|
|
|
jigon
|
May 28 2010, 05:35 PM
|
|
|
some pics...  The amp with some of the supplied accessories..  The first headphone amp that have OLED display..although not necessary for amp functionality, it's a must due to the extra features(bass boost, keylock, usb charge option, sleep timer  etc.). Unfortunately the mirror finish front panel is dust and fingerprint magnet...  Back panel of the amp.. Overall build quality i rate it as above average..in fact, ibasso has better build quality..not sure about other E7 owner but mine, the edge of the panel is quite rough, somehow they don't sand it properly..and the screw hole is off-centered and the depth of the screws is uneven. no wonder the manufacturer include together the silicone case to cover all these imperfections.. Cheers This post has been edited by jigon: May 28 2010, 06:51 PM |
|
|
|
|
Quote
0.0198sec
0.74
7 queries
GZIP Disabled