a noob question here..
coz i gt 2 cars.. so 1 of my car jus park outside my hs..
n 2-3days oni will drive a short wile.. i left it without plug out the battery..
is it ok?

This post has been edited by klng72: Nov 8 2009, 04:19 PM

hmm..a noob question here
my 1.6 BLM idle rpm was at 0.8x when i got my car for last 4 days, but then 2day i saw it become 1.0, may i know is it normal or need to tell SC to do the adjustment??

2-3 days sure no problem one...

Hey guys, i had a problem here with my alarm. The problem is when i tried to press the alarm switch to lock my car, the alarm goes off. And i had already tried to reset the alarm by pressing the buttons inside the car. And also i had check all doors are well close (including the boot).

Anyone mind to help me on this?

This post has been edited by wshiong89: Nov 8 2009, 04:41 PM

Hmm, when you saw it as 1.0? EFI engine RPM during cold start is higher then after warmed up...after warm up and drive for long distance also 1.0?

---

Added on November 8, 2009, 4:42 pmYou might accidentally deactivate your buzzer adi...press your lock/unlock button and the alarm button on the remote at the same time, your buzzer will activate again after 4 beep sound...press both button again will deactivate again...You can find this info in your user manual pg-11 'silent arm/disarm mode'...

This post has been edited by coolkwc: Nov 8 2009, 04:46 PM

normally, when my car jz started the engine still cold. so the idling rpm is 1k
after my car is warmed up, the idling rpm is 0.8k.
sumtimes it might higher abit, but is nvm one; as long as ur car din shut down automatically. shud b ok.

You might accidentally deactivate your buzzer adi...press your lock/unlock button and the alarm button on the remote at the same time, your buzzer will activate again after 4 beep sound...press both button again will deactivate again...You can find this info in your user manual pg-11 'silent arm/disarm mode'...

[/quote]

Thanks for the fast reply bro. Okay. I will try it later.

This post has been edited by wshiong89: Nov 8 2009, 04:48 PM

i dont know. Mybe i want to make up my blm first.

wit soundproof~
it makes ur car more solid+better wen u got play ICE

This post has been edited by cheeann: Nov 8 2009, 05:33 PM

i saw it when i started my car, i just go and start for confirm, it's 1.0..
hmm i did drive for long distance, around 5km consider long?the rpm stay in 1.0..

did u put in D or N?

if has D or N then good, but then 1.6 BLM just has MT haha...

tat's funny man.. haha..
u assume n=neutral, d= gear 1,2,3,4,5 lo..haha

does the temp reach half (3-bars)?
how long to take tat 5km? 10min?

bro..i think dats normal la..if u havent start the car for a afew days, at 1st it will rev up to more than 1k.but only for asplit second coz the ecu trying to adjust the timing again..
but the rpm @ 1k i think its normal coz mine oso like dat.
but who know, i mybe wrong, so u try go sc ask ler..hehehe

once you cold start, its about 1k+, it takes awhile to reach 3 bar, depending on when u start it, like in the afternoon mebe faster or u rev rev alot then it heats up faster? for me, im using 1.3 auto, when I put in neutral, its at 900rpm, if i put D, it goes up higher, i think 1k..

Not a big matter la...no need to cry...

Just observe for few more days lo, if stay like that even after long run, then just went SC to check...

oic, yea the temp reach half (3-bars) and i takes around 10mins for 5km,the rpm stay at 1k rpm even i change my gear to N or D..same haha..
sure, understood already, may consult SC when i reach 1k mileage , quick replies from u all

o... ur car also stil fresh ya.. same v mine.. haha..

a noob question here.. whats the difference when i put P and N when i park? even if u put handbrake when u park on a slope.
i know P is suppose to lock the gears? but does it affect the engine? cause it sounds different when i put P and N