HI every Pro out there, i just OC my Q9650 to 3.78GHZ (420X9.0), when Idle is 42°C but when i run Prime95 it may run up to 70 - 80°C, is it counted as normal?? (i using water cooling)
Below are the setting:-

Ai Overclock Tuner: [Manual]
OC From CPU Level Up: [Auto]
CPU Ratio Control: [9]
FSB Frequency: [420]
FSB Strap to North Bridge: [400M]
PCIE Frequency: [100]
DRAM Frequency: [800]
DRAM Command Rate: [2T]
DRAM Timing Control: [Manual]
CAS# Latency: [5]
RAS# to CAS Delay: [5]
RAS# Precharge: [5]
RAS# Active Time: [15]
RAS# To Ras# Delay: [Auto]
Row Refresh Cycle Time: [Auto]
Write Recovery Time: [Auto]
Read To Precharge Time: [Auto]
Read To Write Delay(S/D): [Auto]
Write To Read Delay(S): [Auto]
Write To Read Delay(D): [Auto]
Read To Read Delay(S): [Auto]
Read To Read Delay(D): [Auto]
Write To Write Delay(S): [Auto]
Write To Write Delay(D): [Auto]
DRAM Static Read Control: [Disabled]
Ai Clock Twister: [Auto]
Transaction Booster: [Auto]
Boost Level: [0]
CPU Voltage: [1.4500v]
CPU PLL Voltage: [1.6v]
North Bridge Voltage: [1.59v]
DRAM Voltage: [2.20v]
FSB Termination Voltage: [1.5v]
South Bridge Voltage: [1.150v]
Loadline Calibration: [Enabled]
CPU GTL Reference: [0.63x]
North Bridge GTL Reference: [0.67x]
DDR2 Channel A REF Voltage: [Auto]
DDR2 Channel B REF Voltage: [Auto]
DDR2 Controller REF Voltage: [Auto]
SB 1.5V Voltage: [Auto]
NB LED Selection: NB Volt
SB LED Selection: SB Volt
CPU LED Selection: CPU Volt
Voltimeter LED: Disabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled

This post has been edited by invisiblelim: Sep 23 2009, 09:11 AM

i changed the Vcore to 1.300V and NB Volt to 1.53V, able to finish the Intel Burn NOrmal and High Mode, is it called as stable??