Wow~~ Your modding is sooo impressive, good job man...
How much it charged for the powder coated on mobo tray?
This post has been edited by chanws8: Sep 22 2009, 03:54 AM
Project: B&W Temjin 07, Watercooled Silvertone TJ-07 in B&W
|
|
 Sep 22 2009, 03:45 AM
Return to original view | Post
#1
|
 
Senior Member
2,165 posts Joined: Aug 2006 From: P4ИD0R4   
|
@TS
Wow~~ Your modding is sooo impressive, good job man... How much it charged for the powder coated on mobo tray? This post has been edited by chanws8: Sep 22 2009, 03:54 AM |
Quote|
|
Sep 22 2009, 06:04 PM
Return to original view | Post
#2
|
|
Senior Member
2,165 posts Joined: Aug 2006 From: P4ИD0R4
|
QUOTE(r4st4m4n @ Sep 22 2009, 01:22 PM) It's not powder coated, it is just painted. It cost me RM 70. The problem was that the mobo tray was chromed and therefore they had to used special chemical for the primer or the pain wouldn't stick. The paint will waer off easily on the screw hole surrounding area after screwed?   |
|
|
Sep 22 2009, 08:03 PM
Return to original view | Post
#3
|
|
Senior Member
2,165 posts Joined: Aug 2006 From: P4ИD0R4
|
QUOTE(r4st4m4n @ Sep 22 2009, 07:14 PM) Not easily but yes, it will wear off if you over tighten them. You have to be a bit careful when putting it together. But even if it wears a bit, this is hidden behind the screw (obviously) so it's not a big issue either Icic...Do u think powder coat will have this kind of wear off problem?  Because i'm planning to do powder coat for my casing... |
| Change to: |  0.0213sec
 0.61
 7 queries
 GZIP Disabled
Time is now: 4th December 2025 - 09:42 AM |
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Powered by Invision Power Board © 2025 IPS, Inc.