Here she goes... haha


btw, last night I tried if the top 140mm exhaust fan can be squeeze in between the top case and the heatsink tapi tak boleh. Now I got a rear fan to blow out and 1 fan in the front to intake air. I am thinking to add another 120mm fan at the side but since the top case fan not working, I am not sure how to position the new fan either to blow out or to suck in the air. I am afraid the air flow not so smooth if wrongly positioned. The normal recommended by cmstorm is 2 intake and 2 blow.

Hey guys....Nice work there....very neat....Many natasha lovers around....THanks for sharing the photos with us.

nas, ur said natasha natasha, but why wallpaper got HAF 1?

curang.. hahaha..

nice rig,.. wooow.. macam nie target scout la..

Cons of 2 my favourite rig

Haf922:vacuum cleaner
            not pure black
         
CM690: ugly side panel
            bukan my favourite led fan
           

So how=.=

---

Added on November 13, 2009, 11:22 amGive some suggestion again~natasha lover

Just my observation, scout's 140mm top fan can only be fit if I change the position the hsf facing upward. No longer bling2 hsf to be seen as usual lah like that, unless looking from bottom view. That also can give me space to put another 2 120mm fans at the side panel.

The image I already attached at earlier posts before, but dun look at the chickenchop psu  I am not sure about other hsf, as what I can see with this xigmatek dark knight and the scout, currently if I am put the hsf vertically the drawbacks are:-
1- I need to remove top 140mm fan
2- I can't fix the 120mm fan (the top) for the side panel if I am planning to put 1 later on, it has 2 as the below only can be use. My current hsf measurement are 160mm+ tall x 120mm+ x 120mm+

If I am going to put the hsf horizontally, 2 problem above solved but I can't see how beautiful the xigmatek dk's bling2 hehe

You mean that v8 is no problem with scout, what is the v8 measurement? as what I can see wooo this v8 is like a tnb's roadside transformer! 

wokey, now I can get my top 140mm fan installed and running after I change the position of hsf from facing forward to upward, not bad I think... hehe

I can see a bit of drop in temp, the previous were around 38°c idle, now at 35°c or 37°c... or just because now is a rainy season?. The fan facing downward is not bad I think, as the bling2 is give some light to below part of the case. I am not very sure what is the cfm for the top 140mm fan, logically the hot hair going up and the fan help to dissipates the heat more efficiently, imo.

Xigmatek Midgard user here.

Lot of improvement for the new release.

Metal they use more solid not like first bacth.
Hard disk holder more stable "xde longar-2".
Adding extra hole for more alternative cable management.
All revet in black color (pure black).

The design clear side panel not so good in my opinion.
The only metal not solid was 5.25 to 3.5 holder. I think they using old stock.

i still like haf922 due to nas06 curse