Outline ·
[ Standard ] ·
Linear+
Panasonic TH-P42X10K & TH-P50X10K Thread, New 2009 X-Series Plasma from Panasonic
|
sotong168
|
 May 18 2009, 03:40 PM
|
|
QUOTE(anfieldude @ May 17 2009, 07:56 AM) Don't worry about the heat and lifetimes. The plasmas work at higher temperatures. This is the nature of the panels. They have very capable temperature sensors and overcurrent protectors that will shut off should it reach critical temperatures. This is a requirement. So don't worry about the heat generated and the long hours viewing time. thks for clearing my doubt & worry. QUOTE(eddie89 @ May 17 2009, 03:19 PM) guys, how to check the usage hour for the TH-P50X10K? Thanks! |
|
|
|
|
|
sotong168
|
May 21 2009, 02:10 AM
|
|
|
@anfieldude, mind to share the settings? thks~
Added on May 21, 2009, 2:11 ambtw, the setting for hd is applicable for sd also?
This post has been edited by sotong168: May 21 2009, 02:11 AM
|
|
|
|
|
|
sotong168
|
May 21 2009, 07:23 AM
|
|
|
ok thks... so podrunner, pls post up  |
|
|
|
|
|
sotong168
|
May 22 2009, 03:02 AM
|
|
|
thks for sharing but as mentioned, those service menu calibration shud be in how many steps forward & backward as the initial setting is different. anyhow, appreciate the info~~~ thks~
|
|
|
|
|
|
sotong168
|
Jun 2 2009, 05:43 PM
|
|
|
i set contrast to 100%, with dynamic mode during 100hr run-in (the rest at default), 30s with SDHC mode and looping. if u r using SDHC, make sure u chg the setting in picture viewing mode. how much u bought yours? welcome to the club.
|
|
|
|
|
|
sotong168
|
Jun 2 2009, 09:07 PM
|
|
|
QUOTE(podrunner @ Jun 2 2009, 07:20 PM) ventured into the service menu settings yet? no yet  kind of tie-up with my work lately  QUOTE(superyaw @ Jun 2 2009, 07:30 PM) Should we set higher contrast and brightness during break in period or lower? I keep searching for the previous post, some said we should lower down the contrast and brightness during the 1st 100 -200 hours of break in but some said we should set it to higher constrast and brightness by using dynamic mode with the break in dvd. Anyone can advise? setting high is to expedite the burn-in process, afaik some prefer low due to worry of overheating or to play safe just in case hiccup happen This post has been edited by sotong168: Jun 2 2009, 09:07 PM |
|
|
|
|
|
sotong168
|
Jun 3 2009, 05:25 PM
|
|
|
|
|
|
|
|
|
sotong168
|
Jun 13 2009, 09:15 AM
|
|
|
my place is offering 42" @ rm2599 now, price war, good for consumer  |
|
|
|
|
Quote
0.0260sec
0.73
7 queries
GZIP Disabled