QUOTE(jackyjin @ Mar 29 2009, 01:38 PM)
i wanna ask all sifus here...how much does it cost to get a wira 1.5 engine from half cut shop?
i might need change and the mechanic say it's about rm1800 (in KL)...is it so expensive??
1.8k is kaotim everything?i might need change and the mechanic say it's about rm1800 (in KL)...is it so expensive??
QUOTE(shinjite @ Mar 29 2009, 02:23 PM)
fark, yesterday went to lowyat, on the way there, rear left tyre punctured
Found out today inner sidewall there bocor, fark, don't even know how the heck that happen. Air pressure all was okay, !$!#%!#@%^@$ End up must get new tyre, can't patch.
Then today service the brakes because jam and ended up changing the handbrake cable because right side 1 pulak jam, can't release properly. !#$!#%^!@#
On the spot 2 days only a lot of cash fly liao, today do brakes and everything plus original handbrake cable RM220, tomorrow new tyre plus alignment and balancing again, another RM2xx sure fly
KNN betul....
now the handbrake cable 220 d ar, last yr when i change is 180 only.Found out today inner sidewall there bocor, fark, don't even know how the heck that happen. Air pressure all was okay, !$!#%!#@%^@$ End up must get new tyre, can't patch.
Then today service the brakes because jam and ended up changing the handbrake cable because right side 1 pulak jam, can't release properly. !#$!#%^!@#
On the spot 2 days only a lot of cash fly liao, today do brakes and everything plus original handbrake cable RM220, tomorrow new tyre plus alignment and balancing again, another RM2xx sure fly
KNN betul....
Mar 29 2009, 03:56 PM

Quote
0.0173sec
0.43
6 queries
GZIP Disabled